U8201A AGILENT TECHNOLOGIES, U8201A Datasheet - Page 8

• Manufacturer Part Number: U8201A
• Description: U3400 U3606A U3401A U3402A
• Manufacturer: AGILENT TECHNOLOGIES

Specifications of U8201A

• Voltage Rating: 1000V
• Kit Contents: Extension Test Leads, Test Probes, Alligator Clips, SMT Grabbers, Banana Plugs.
• For Use With: U3400 Series, U3401A, U3402A, And U3606A
• Lead Free Status / RoHS Status: na

Digital multimeter specifications (continued)
Supplementary specifications
AC voltage
Measurement method
Maximum input voltage
Input impedance
Input protection
Crest factor
Peak input
Response time
Overload ranging
AC current
Measurement method
Maximum input current
Burden voltage and shunt resistance
Input protection
Crest factor
Peak input
Response time
Resistance
Measurement method
Open circuit voltage
Input protection
Response time
Low-resistance
Measurement method
Input protection
Continuity
Measurement method
Open circuit voltage
Audible tone
Input protection
AC coupled true rms
750 V
1 MΩ ± 2% range (typical) in parallel with capacitance < 120 pF
750 V
For < 5:1 errors included. Limited by the peak input and 100 kHz bandwidth. Maximum 3.0 at
full scale.
300% of range. Limited by maximum input.
Approximately 2.5 s when the displayed reading reaches 99.9% AC rms value of the tested
input signal at the same range.
Will select higher range if peak input overload is detected during auto range. Overload is
reported in manual ranging.
AC coupled true rms
10 mA to 3.0 A DC or AC rms
• < 0.2 V, 10 Ω for 10 mA range
• < 0.2 V, 1 Ω for 100 mA range
• < 0.3 V, 0.1 Ω for 1 A range
• < 0.7 V, 0.01 Ω for 3 A range
Protected with 3.15 A/500 V, FF fuse
For < 5:1 errors included. Limited by the peak input and 100 kHz bandwidth. Maximum 3.0 at
full scale.
300% of range. Limited by maximum input.
Approximately 2.5 s when the displayed reading reaches 99.9% AC rms value of the tested
input signal at the same range.
Two-wire, open-circuit voltage limited to < 5 V
< +5.0 V
1000 Vrms on all ranges, < 0.3 A short circuit
Approximately 0.15 seconds for 1 MΩ and ranges below 1 MΩ
Four-wire; test current is sent from the FORCE terminals and resistance measured at the
SENSE terminals.
• FORCE terminals: 3.15 A/250 V
• SENSE terminals: 1000 V
0.83 mA ± 0.2% constant current source
< +5.0 V
Continuous beeping when reading is less than the threshold resistance of 10 Ω at 1.0 kΩ
range
1000 V
rms
rms
rms
/1200 V
on all ranges
dc
dc
on all ranges, < 0.3 A short circuit
peak
/3 x 10
8
7
V-Hz of product
rms
on all ranges, < 0.3 A short circuit