FLUKE-287 CALIBRATED Fluke, FLUKE-287 CALIBRATED Datasheet - Page 12
![MULTIMETER, DIGITAL, HANDHELD](/photos/27/68/276802/4615551_sml.jpg)
FLUKE-287 CALIBRATED
Manufacturer Part Number
FLUKE-287 CALIBRATED
Description
MULTIMETER, DIGITAL, HANDHELD
Manufacturer
Fluke
Datasheet
1.FLUKE-287_CALIBRATED.pdf
(88 pages)
Specifications of FLUKE-287 CALIBRATED
Dmm Type
Handheld
Voltage Measuring Range Dc
50 MV To 50 V
Voltage Measuring Range Ac
500 V To 1000 V
Current Measuring Range Dc
500µA To 10A
Current Measuring Range Ac
500µA To 10A
Lead Free Status / RoHS Status
na
287/289
Users Manual
2
Make sure the battery door is closed and
latched before operating the Meter.
Remove test leads from the Meter before
opening the battery door.
Inspect the test leads for damaged insulation
or exposed metal. Check the test leads for
continuity. Replace damaged test leads before
you use the Meter.
Do not apply more than the rated voltage, as
marked on the Meter, between the terminals or
between any terminal and earth ground.
Never operate the Meter with the cover
removed or the case open.
Use caution when working with voltages above
30 V ac rms, 42 V ac peak, or 60 V dc. These
voltages pose a shock hazard.
Use only the replacement fuses specified by
the manual.
Use the proper terminals, function, and range
for measurements.
Avoid working alone.
When measuring current, turn off circuit power
before connecting the Meter in the circuit.
Remember to place the Meter in series with the
circuit.
When making electrical connections, connect
the common test lead before connecting the
live test lead; when disconnecting, disconnect
the live test lead before disconnecting the
common test lead.
Do not use the Meter if it operates abnormally.
Protection may be impaired. When in doubt,
have the Meter serviced.
Do not operate the Meter around explosive
gas, vapor, or dust.
Use only 1.5 V AA batteries, properly installed
in the Meter case, to power the Meter.
When servicing the Meter, use only specified
replacement parts.
When using probes, keep fingers behind the
finger guards on the probes.
Do not use the Low Pass Filter option to verify
the presence of hazardous voltages. Voltages
greater than what is indicated may be present.
First, make a voltage measurement without the
filter to detect the possible presence of
hazardous voltage. Then select the filter
function.
Only use test leads that have the same voltage,
category, and amperage ratings as the meter
and that have been approved by a safety
agency.