72-7730 TENMA, 72-7730 Datasheet - Page 38
![MULTIMETER DIGITAL HANDHELD, 4-1/2 DIGIT](/photos/27/66/276662/4316766_sml.jpg)
72-7730
Manufacturer Part Number
72-7730
Description
MULTIMETER DIGITAL HANDHELD, 4-1/2 DIGIT
Manufacturer
TENMA
Datasheet
1.72-7730.pdf
(72 pages)
Specifications of 72-7730
Dmm Type
Handheld
Voltage Measuring Range Dc
200mV - 1000V
Voltage Measuring Range Ac
2V - 1000V
Current Measuring Range Dc
200µA To 10A
Current Measuring Range Ac
200µA To 10A
Lead Free Status / RoHS Status
na
Model 72-7730: OPERATING MANUAL
Note
l
l
l
l
l
When measuring low resistance, the test leads can
add 0.1 to 0.2 of error to resistance measurement.
To test the leads, touch the probe tips together and
read the resistance of the leads. If necessary, you
can press REL
For high-resistance measurement (>1M ), it is normal
taking several seconds to obtain a stable reading.
In order to obtain precision readings, use the test
lead as short as possible.
The LCD displays OL indicating open-circuit or the
tested resistor value is higher than the maximum
range of the Meter.
When testing the resistance signal from the calibrator,
it is necessary to press and hold the RANGE while
turning on the Meter to change the maximum display
to 2000 counts but the accuracy remains unchanged.
When resistance measurement has been completed,
disconnect the connection between the testing leads
and the circuit under test and remove testing leads
away from the input terminals.
to automatically subtract this value.
D. Testing for Continuity
To avoid harms to you, please do not attempt to input
voltage higher than 60V DC or 30V rms AC.
To avoid possible damages to the Meter or to the
devices under test, disconnect circuit power and
discharge all the high-voltage capacitors before
measuring continuity.
To test for continuity, set up the Meter as Figure 3-4
and do the following:
1.
2.
3.
The BLUE button cycles among resistance, continuity,
and diode.
Insert the red test lead into the
black test lead into the COM terminal.
Set the rotary switch to
to select
test leads across with the object being tested.
The beeper comes on continuously for open
conditions, that is test resistance
Warning
measurement mode and connet the
; press BLUE button
terminal and the
50 .
35