PCI-AC48 OPTO 22, PCI-AC48 Datasheet - Page 2

• Manufacturer Part Number: PCI-AC48
• Description: Computers, Interface Cards
• Manufacturer: OPTO 22
• Type: PCIr

Specifications of PCI-AC48

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

PAGE
2
mistic™ Remote I/O and Optomux® I/O
The PCI-AC48 adapter card supports communication to Opto 22
mistic remote I/O as well as Opto 22’s Optomux I/O. A mistic remote
I/O bus uses one twisted-pair cable for communication; however, a
second pair can optionally be used in systems needing mistic
interrupt capability. The communication cable must be terminated
Opto 22 • 43044 Business Park Drive • Temecula, CA 92590-3614 • www.opto22.com
SALES 800-321-6786 • 951-695-3000 • FAX [phone] • [e-mail] • SUPPORT 800-835-6786 • 951-695-3080 • FAX [phone] • [e-mail]
© 2006 Opto 22. All rights reserved. Dimensions and specifications are subject to change. Brand or product names used herein are trademarks or registered trademarks of their respective companies or organizations.
Computer Interface
Ports
Isolation
Communications
Baud Rates
Cable Length Distance
Termination
Biasing
Indicators
System Requirements
for Software Driver
Power Requirements
Operating Temperature
Storage Temperature
Humidity
32-bit, 33 MHz PCI bus, PCI Specification Revision 2.2
2,500 VAC transient
RS-485 2-wire or 4-wire operation
200 Ohm termination for RS-485 and IRQ
(DIP switch configurable)
(DIP switch configurable)
Transmit, Receive, and IRQ LEDs for each serial port
Microsoft Windows 2000 or Windows XP
5 VDC @ 600 mA
0 °C to 70 °C
–30 °C to 85 °C
Two serial ports, configurable for the following:
Serial link to 460,800 baud
Up to 3,000 ft. (915 m) @ 115,200 baud
RS-485 pull-up/pull-down biasing
95% relative humidity, non-condensing
• Two ports when used in RS-485 2-wire mode, or
• One port when used in RS-485 4-wire mode
Typical Conntection Using B3000 Serial Brains
at both ends of the cable (the PCI-AC48 will usually be at one end).
The communication cable must also be biased at one location only,
typically also at the PCI-AC48 card. Bias and termination are set
using DIP switches.
Specifications
Traditional PC Adapter Card