LAN91C96-MS SMSC, LAN91C96-MS Datasheet - Page 92

• Manufacturer Part Number: LAN91C96-MS
• Description: Ethernet ICs Non-PCI 10 Mbps Ethernet MAC
• Manufacturer: SMSC
• Type: Single Chip MAC and PHY Controllerr

Specifications of LAN91C96-MS

• Ethernet Connection Type: 10 Base-T, 100 Base-TX
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• Product: Ethernet Controllers
• Number Of Transceivers: 1
• Standard Supported: 802.3, 802.3u
• Data Rate: 10 Mbps, 100 Mbps
• Supply Voltage (max): 5 V
• Supply Voltage (min): 0 V
• Supply Current (max): 95 mA
• Maximum Operating Temperature: + 70 C
• Package / Case: TQFP-100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Chapter 11 Operational Description
11.1
Note:
11.2
Revision 1.0 (10-24-08)
Input Voltage Levels for V
I Type Input Buffer
Low Input Level
High Input Level
IS Type Input Buffer
Low Input Level
High Input Level
Schmitt Trigger Hysteresis
Maximum Guaranteed Ratings
Operating Temperature Range ...................................................................................................0°C to 70°C
Storage Temperature Range ...............................................................................................-55°C to +150°C
Lead Temperature Range (soldering, 10 seconds) ............................................................................+325°C
Positive Voltage on any pin, with respect to Ground .....................................................................V
Negative Voltage on any pin, with respect to Ground ........................................................................... -0.3V
Maximum V
*Stresses above those listed above could cause permanent damage to the device. This is a stress rating
only and functional operation of the device at any other condition above those indicated in the operation
sections of this specification is not implied.
When powering this device from laboratory or system power supplies, it is important that the Absolute
Maximum Ratings not be exceeded or device failure can result. Some power supplies exhibit voltage
spikes on their outputs when the AC power is switched on or off. In addition, voltage transients on the AC
power line may appear on the DC output. If this possibility exists, it is suggested that a clamp circuit be
used.
DC Electrical Characteristics
(T
A
=0°C to 70°C, V
PARAMETER
CC
.......................................................................................................................................... +7V
CC
= +5.0 V ± 10%, or V
cc
= 5.0V
DATASHEET
SYMBOL
V
V
V
V
V
IHIS
HYS
ILIS
ILI
IHI
CC
Page 92
= +3.3 V ± 10% as noted for Revisions E and later)
MIN
2.0
2.2
*
Non-PCI Single-Chip Full Duplex Ethernet Controller with Magic Packet
TYP
250
MAX
0.8
0.8
UNITS
mV
V
V
V
V
TTL Levels
Schmitt Trigger
Schmitt Trigger
COMMENTS
SMSC LAN91C96 5v&3v
CC
Datasheet
+ 0.3V