CS4222-KS Cirrus Logic Inc, CS4222-KS Datasheet - Page 24

• Manufacturer Part Number: CS4222-KS
• Description: Audio CODECs IC 20-Bit Stereo Codec w/Vol Cntrl
• Manufacturer: Cirrus Logic Inc

Specifications of CS4222-KS

• Number Of Adc Inputs: 2
• Number Of Dac Outputs: 2
• Conversion Rate: 48 KSPs
• Interface Type: Serial (I2C, SPI)
• Resolution: 20 bit
• Maximum Operating Temperature: + 70 C
• Mounting Style: SMD/SMT
• Package / Case: SSOP-28
• Minimum Operating Temperature: - 10 C
• Number Of Channels: 2 ADC, 2 DAC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Idle Channel Noise / Signal-to-Noise-Ratio
Total Harmonic Distortion (THD)
Interchannel Isolation
Frequency Response
Interchannel Gain Mismatch
Gain Error
Gain Drift
Offset Error
24
The ratio of the rms analog output level with 1kHz full scale digital input to the rms analog
output level with all zeros into the digital input. Measured A-weighted over a 10Hz to 20kHz
bandwidth. Units in decibels. This specification has been standardized by the Audio
Engineering Society, AES17-1991, and referred to as Idle Channel Noise. This specification has
also been standardized by the Electronic Industries Association of Japan, EIAJ CP-307, and
referred to as Signal-to-Noise-Ratio.
THD is the ratio of the test signal amplitude to the rms sum of all the in-band harmonics of the
test signal. Units in decibels.
A measure of crosstalk between channels. Measured for each channel at the converter’s output
with no signal to the input under test and a full-scale signal applied to the other channel. Units
in decibels.
A measure of the amplitude response variation from 20Hz to 20kHz relative to the amplitude
response at 1kHz. Units in decibels.
For the ADCs, the difference in input voltage that generates the full scale code for each
channel. For the DACs, the difference in output voltages for each channel with a full scale
digital input. Units are in decibels.
The deviation from the nominal full scale output for a full scale input.
The change in gain value with temperature. Units in ppm/°C.
For the ADCs, the deviation in LSB’s of the output from mid-scale with the selected inputs tied
to a common potential. For the DAC’s, the differential output voltage with mid-scale input
code. Units are in volts.
CS4222
DS236PP3