CRH01(TE85R,Q,M) Toshiba, CRH01(TE85R,Q,M) Datasheet - Page 2

• Manufacturer Part Number: CRH01(TE85R,Q,M)
• Description: DIODE HI EFF 200V 1A S-FLAT
• Manufacturer: Toshiba

Specifications of CRH01(TE85R,Q,M)

• Voltage - Forward (vf) (max) @ If: 980mV @ 1A
• Voltage - Dc Reverse (vr) (max): 200V
• Current - Average Rectified (io): 1A
• Current - Reverse Leakage @ Vr: 10µA @ 200V
• Diode Type: Standard
• Speed: Fast Recovery =< 500ns, > 200mA (Io)
• Reverse Recovery Time (trr): 35ns
• Mounting Type: Surface Mount
• Package / Case: 3-2A1A (S-Flat)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Capacitance @ Vr, F: -

Marking
Standard Soldering Pad
Handling Precaution
The maximum ratings denote the absolute maximum ratings, which are rated values and must not be exceeded
during operation, even for an instant. The following are the general derating methods that we recommend when
you design a circuit with a device.
This rating specifies the non-repetitive peak current in one cycle of a 50-Hz sine wave, condition angle 180.
Therefore, this is only applied for an abnormal operation, which seldom occurs during the lifespan of the device.
We recommend that a device be used at a Tj of below 120°C under the worst load and heat radiation conditions.
Thermal resistance between junction and ambient fluctuates depending on the device’s mounting condition. When
using a device, design a circuit board and a soldering land size to match the appropriate thermal resistance value.
Please refer to the Rectifiers databook for further information.
1.2
Abbreviation Code
V
I
F(AV)
RRM
1.2
H1
:
:
We recommend that the worst case voltage, including surge voltage, be no greater than 80% of the
maximum rating of V
circuit. V
account designing a device at low temperature.
We recommend that the worst case current be no greater than 80% of the maximum rating of I
Carry out adequate heat design. If you can’t design a circuit with excellent heat radiation, set the
margin by using an allowable Tamax-I
2.8
RRM
Part No.
CRH01
has a temperature coefficient of 0.1%/°C. Take this temperature coefficient into
Unit: mm
RRM
for a DC circuit and be no greater than 50% of that of V
F(AV)
2
curve.
RRM
2004-07-01
CRH01
for an AC
F(AV)
.