M2BJ-BH24D-D Omron, M2BJ-BH24D-D Datasheet - Page 44

• Manufacturer Part Number: M2BJ-BH24D-D
• Description: Buzzer
• Manufacturer: Omron
• Series: M2BJ-BHr
• Type: Piezo Indicator, Internal Driver

Specifications of M2BJ-BH24D-D

• Frequency: 2.8kHz
• Voltage - Rated: 12 ~ 24VDC
• Current Rating: 50mA
• Size / Dimension: Rectangular - 26mm L x 22mm W x 44.5mm H
• Mounting Type: Panel Mount
• Sound Pressure Level: 70dB ~ 100dB
• Operating Mode: Continuous/Intermittent
• Voltage Range: 12 ~ 24VDC
• Termination: Solder Tab (s)
• Color: Black
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Capacitance @ Frequency: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: A16 Pushbutton, Selector Switches, and Key Switches
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: M2BJBH24DD

Correct Use
J NUT MOUNTING
Insert the buzzer unit from the front of the panel and tighten the
mounting nut inserted from the rear of the panel.
Since a projection exists on the rear portion of the buzzer unit, if
the mounting nut cannot be fitted into position, turn the nut
slightly.
The tightening torque of the mounting nut should be less than
5 kg-cm.
Solder the terminals after mounting the nut. Otherwise, the
terminals, when thickened by solder, may prevent the nut from
being screwed down onto the buzzer unit.
J MOUNTING
Tighten the mounting nut at a torque of less than 5 kg-cm.
J WIRING
Exercise caution that the input terminals are not short-circuited
by the short-circuiting jumper.
Finish soldering within 5 seconds with a 30 watt soldering iron, or
within 3 seconds at a solder temperature of 240°C. For about a
minute after soldering, do not apply any force to the buzzer unit,
to avoid deforming the softened plastic buzzer unit base.
Use an non-corrosive, resin-based soldering flux.
J SNAP-IN MOUNTING
Attach the mounting leaf spring to the buzzer. Engage the edges
of the leaf spring in the two grooves on the threaded section of
the buzzer. After inserting the leaf spring edges into the grooves,
confirm that the leaf spring has seated. Be sure to attach both
leaf springs.
Insert the buzzer assembly into the hole on the mounting panel
from the front.
M2BJ-B
45
J SHORT-CIRCUITING JUMPER
The buzzer sounds continuously or intermittently depending on
how the short-circuiting bracket is attached to the case guide.
When the bracket is attached with the triangle on it facing
direction A (PC board side), the buzzer sounds intermittently.
To produce continuous sounds, attach the bracket to the case
guide so that the triangle on the bracket faces direction B.
M2BJ-B