LEDRR62X62W BANNER ENGINEERING, LEDRR62X62W Datasheet - Page 3

• Manufacturer Part Number: LEDRR62X62W
• Description: LEDRR62X62W 24V RED
• Manufacturer: BANNER ENGINEERING

* +V = 24V dc ± 10%; -V = dc common
The ring light bracket attaches to the top of the PresencePLUS Pro, ProII or Mini Pro lens block, using the hardware
kit provided.
Sensing Shiny Surfaces
To eliminate direct reflections without using polarizing filters, angle the sensor approximately 15° (or more) from
perpendicular to a shiny surface.
Polarizing Kit
If it is necessary to mount the camera at a 90° angle to a shiny surface, the polarizing filter kit provides filters for
both the LED ring light and sensor to reduce the negative effects of strong, direct light reflections. The red filter kit
(FLTR) is included with the polarizing kit. When light colors other than red are used, discard the red filter in the po-
larizing kit and use the proper filter (see Models tables). The polarizing filters reduce the amount of light returned to
the sensor.
P/N 108626 rev. D
Note: Before installing this light it is recommended that an ambient light filter be installed behind the lens. The
filter improves image quality by reducing unwanted ambient light.
Light Wire
Brown
White
Blue
PresencePLUS Pro Controller
Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Terminal Block
Pin 4 (strobe)
Pin 1 (+V*)
Pin 2 (-V*)
Installing the Ring Light
Wiring Table
Tel: [phone]
External Power Supply
(Strobed)
+5V dc to +24V dc
+V
-V
-V
OFF
ON
External Power Supply
(Continuous)
+V
-V
-V
3