8-435626-6 Tyco Electronics, 8-435626-6 Datasheet - Page 3

• Manufacturer Part Number: 8-435626-6
• Description: DIP SW 2 POSN W/TAPE AU
• Manufacturer: Tyco Electronics
• Series: 7000r

Specifications of 8-435626-6

• Rohs Information: 8-435626-6
• Circuit: SPST
• Number Of Positions: 2
• Contact Rating @ Voltage: 0.1A @ 5VDC
• Actuator Type: Rocker
• Actuator Level: Flush
• Mounting Type: Through Hole
• Orientation: Top Actuated
• Washable: Yes
• Switch Type: DIP
• Actuator: Rocker, Recessed
• Terminal Pitch: 2.54 mm
• Contact Form: SPST
• Termination Style: Through Hole
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3.2. PC Board Installation
Rev B
Use Light Pressure
to Insert Switch
1. Make a layout on the pc board according to the
dimensions shown in Figure 4.
2. Make certain all contact leads have started entry
into holes. Grip sides of switch and push switch
into pc board until it is bottomed.
3. Hold switch at a slight angle and start one row
on contact leads into pc board holes. Do NOT
over--insert. Switch should be rotated until second
row of contact leads are aligned with opposite row
of contact holes.
NOTE
Protective Cover
7.62 [.300] Ref
2.54 [.100] Ref
To hold switch in place during wave soldering, the
four outside contact leads may be clinched
inward at 45. Refer to Figure 5.
Figure 3
Figure 4
NOTE: These same procedures
apply to socket installation.
Grip Here
Rotate to Align Second
Row - - Then Push Down
on Ends of Switch
Cover Latch
4. SWITCH PROGRAMMING
After the switch has been inserted into the DIP socket
or soldered onto the pc board, proceed as follows:
Housing Bottomed
on PC Board
Remove Seal from Top
Left to Bottom Right
(Diagonal Across the
Switch)
Remove Tape
Seal from
End
NOTE
1. Remove seal from the switches, see Figure 6.
For pc board soldering and cleaning procedures,
and recommended solvents, refer to Application
Specification 114- - 1056.
Clinched Contact Lead (Inward Only)
Figure 5
Figure 6
Low- - Profile Switch
Masking Material
Seal
Standard- - Profile or
Side- - Actuated Switch
PC Board
408- 7779
3 of 4