D3C-2210 Omron, D3C-2210 Datasheet - Page 4

• Manufacturer Part Number: D3C-2210
• Description: SUBMINIATURE BASIC SWITCH
• Manufacturer: Omron
• Series: D3Cr
• Type: Detection Switchr

Specifications of D3C-2210

• Circuit: SPDT
• Switch Function: On-Mom
• Contact Rating @ Voltage: 0.1A @ 30VDC
• Actuator Type: Angled Toggle (Detector)
• Mounting Type: Through Hole
• Termination Style: PC Pin
• Operating Force: 130gf
• Contact Form: SPDT
• Contact Rating: 0.1 Amp
• Actuator: Lever, Hinge
• Body Style: Ultra Subminiature
• Current, Rating: 0.1 A
• Dielectric Strength: 250 VAC
• Mounting Hole Size: 1 mm
• Number Of Poles: 1
• Special Features: Detection Switch, Toggle Actuator with Slide Contacts
• Termination: Through Hole
• Voltage, Rating: 30 VDC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: D3C2210; SW226

■ Mounting holes
When mounting the D3C with screws, use M1.6 mounting screws with plain washers or spring washers. Tighten the screws to a torque of
2
4.9 to 9.8 X 10
N.
Note: Unless otherwise specified, a tolerance of ± 0.2 mm applies to all dimensions.
Precautions
■ Mounting
Refer to the following dimensions for PCB mounting. The distance
between two adjacent terminals is 2.54 mm.
When soldering each terminal of the D3C, apply a soldering iron
rated at 30 W for no longer than three seconds. Do not impose any
external force to the terminals for approximately one minute after the
terminals are soldered.
Make sure that the terminals of the D3C are insulated from one
another and the ground.
Do not allow the lever to be pressed beyond the TTP.
D3C
3
Detection Switch