MTCBA-C1-EN2-N2 Multi-Tech Systems, MTCBA-C1-EN2-N2 Datasheet - Page 56
![no-image](/images/no-image-200.jpg)
MTCBA-C1-EN2-N2
Manufacturer Part Number
MTCBA-C1-EN2-N2
Description
ROUTER WIRELESS DUAL CDMA
Manufacturer
Multi-Tech Systems
Series
MultiModem® rCellr
Datasheets
1.SF100-G.pdf
(4 pages)
2.MTCBA-C1-N16.pdf
(135 pages)
3.MTCMR-E1.pdf
(16 pages)
4.MTCMR-E1.pdf
(79 pages)
5.MTCMR-E1.pdf
(2 pages)
6.MTCMR-C1-N2.pdf
(2 pages)
Specifications of MTCBA-C1-EN2-N2
Function
Transceiver, CDMA, Router
Modulation Or Protocol
CDMA2000
Frequency
800MHz, 1.9GHz
Applications
Sprint Networks (USA)
Interface
RJ-45, RS-232
Voltage - Supply
9 V ~ 32 V
Package / Case
Module
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
881-1064
Chapter 4 – Using the Web Management Software
S erial Port > Client Settings
9 8 B
The TCP/UDP client feature enables the router to act as a proxy TCP/UDP client to the serial terminal connected to the DE9,
RS232 port on the router thus facilitating the serial terminal to access any TCP/UDP server on the LAN/WAN. Once the session,
serial terminal to TCP/UDP server, is opened successfully, it allows two-way traffic between the serial device and the remote
server.
Initial connection setup for the TCP/UDP client is as shown below:
T CP/UDP – Client Configuration
9 9 B
S ubmit Button
1 0 0 B
56
Configures TCP/UDP Client through which the serial terminal connected to the RS-232 connector, DE9 on the back of the
unit communicates with the remote TCP/UDP server on the LAN/WAN.
Status:
Client Type:
Primary Server:
Port:
Secondary Server:
Port:
Connection start By:
Connection Terminate By:
Escape Sequence:
Inactivity timeout:
Others:
Click the Submit button to save these settings.
TCP/UDP
Server
Sets the client status to either Enable or Disable. The default is Disable
Sets the client to either TCP or UDP. The default is TCP.
Enter the Primary Server IP address or Hostname. The default is blank.
If a Primary Server IP address or hostname is enabled, enter the port number of the serve.
Enter the Secondary Server IP address or Hostname. The default is blank.
If a Secondary Server IP address or hostname is enabled, enter the port number of the
server.
Sets the trigger (Carriage Return (CR), DTR Assert, or Always on) in the serial port by which
the connection starts. The default is Carriage Return (CR).
Set the escape sequence characters at which the connection should terminate.
Set the inactivity timeout at which the connection should terminate.
The other terminating sequences are: DTR-toggle or Always-On.
DTR-toggle:
Always-On:
Sets the connection terminate sequence as follows:
LAN / WAN
If DTR status goes low, the connection terminates.
Sets the terminate sequence as Always-on.
Router hardware
TCP/UDP
Client
Multi-Tech Systems, Inc. MultiModem rCell User Guide
Connector
DE9
HyperTerminal /
Minicom
Device
Serial