CS5464-ISZR Cirrus Logic Inc, CS5464-ISZR Datasheet - Page 15

• Manufacturer Part Number: CS5464-ISZR
• Description: IC 3-Channel Single Phase Power/Energy
• Manufacturer: Cirrus Logic Inc
• Type: Single Phase Power/Energy ICr

Specifications of CS5464-ISZR

• Input Impedance: 30 KOhm
• Measurement Error: 0.1%
• Voltage - I/o High: 0.8V
• Voltage - I/o Low: 0.2V
• Current - Supply: 3.5mA
• Voltage - Supply: 4.75 V ~ 5.25 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 28-SSOP
• Meter Type: Single Phase
• Output Voltage Range: 2.4 V to 2.6 V
• Output Current: 100 mA
• Input Voltage Range: 3.135 V to 5.25 V
• Input Current: 10 mA
• Power Dissipation: 500 mW
• Operating Temperature Range: - 40 C to + 85 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1554 - BOARD EVAL FOR CS5464 ADC
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

4.4 DC Offset and Gain Correction
The system and chip inherently have gain and offset er-
rors which can be removed using the gain and offset
registers. (See
39). Each measurement channel has its own registers.
For every channel, the output of the IIR filter is added to
the offset register and multiplied by the gain register.
4.5 High-pass Filters
Optional high-pass filters (HPF in Figures
move any DC from the selected signal paths. Subse-
quently, DC will also be removed from power, and all
low-rate results. (see Figures 5).
Each energy channel has a current and voltage path. If
an HPF is enabled in only one path, a phase-matching
filter (PMF) is applied to the other path which matches
the amplitude and phase delay of the HPF in the band
DS682F1
Section 9. System Calibration
3
and 4) re-
on page
of interest, but passes DC. For more information, see
6.5 High-pass Filters
plexers drive the I1 , V1 , I2 , and V2 result registers.
4.6 Low-Rate Calculations
Low-rate results are derived from sample-rate results
integrated over N samples, where N is the value stored
in the Cycle Count register. The low-rate interval is the
sample interval multiplied by N .
4.7 RMS Results
The root mean square ( RMS in
are performed on N instantaneous voltage and current
samples, using the formula:
I RMS
on page 19. The HPF filter multi-
=
-------------------- -
n
N 1
∑
=
–
N
0
Figure
I n
2
5) calculations
CS5464
15