ADF4360-0BCPZRL7 Analog Devices Inc, ADF4360-0BCPZRL7 Datasheet - Page 17

• Manufacturer Part Number: ADF4360-0BCPZRL7
• Description: IC,FREQUENCY SYNTHESIZER,BICMOS,LLCC,24PIN,PLASTIC
• Manufacturer: Analog Devices Inc
• Type: Fanout Distribution, Integer N Synthesizer (RF)r

Specifications of ADF4360-0BCPZRL7

• Pll: Yes
• Input: CMOS
• Output: Clock
• Number Of Circuits: 1
• Ratio - Input:output: 1:2
• Differential - Input:output: No/No
• Frequency - Max: 2.725GHz
• Divider/multiplier: Yes/No
• Voltage - Supply: 3 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 24-LFCSP
• Frequency-max: 2.725GHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: EVAL-ADF4360-0EBZ1 - BOARD EVALUATION FOR ADF4360-0
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Hardware Power-Up/Power-Down
If the ADF4360-0 is powered down via the hardware (using the
CE pin) and powered up again without any change to the N
counter register during power-down, it locks at the correct fre-
quency because the part is already in the correct frequency
band. The lock time depends on the value of capacitance on the
C
capacitance of 440 nF on this pin enables lock times of <600 µs.
The N counter value cannot be changed while it is in power-
down because the part may not lock to the correct frequency on
power-up. If it is updated, the correct programming sequence
for it after power-up is to the R counter latch, followed by the
control latch, and finally the N counter latch, with the required
interval between the control latch and N counter latch, as
described in the Initial Power-Up section.
N
pin, which is <5 ms for 10 µF capacitance. The smaller
Rev. A | Page 17 of 24
Software Power-Up/Power-Down
If the ADF4360-0 is powered down via the software (using the
control latch) and powered up again without any change to the
N counter latch during power-down, it locks at the correct fre-
quency because it is already in the correct frequency band. The
lock time depends on the value of capacitance on the C
which is <5 ms for 10 µF capacitance. The smaller capacitance
of 440 nF on this pin enables lock times of <600 µs.
The N counter value cannot be changed while it is in power-
down because the part may not lock to the correct frequency on
power-up. If it is updated, the correct programming sequence
for it after power-up is to the R counter latch, followed by the
control latch, and finally the N counter latch, with the required
interval between the control latch and N counter latch, as
described in the Initial Power-Up section.
ADF4360-0
N
pin,