ADA4062-2ARZ-R7 Analog Devices Inc, ADA4062-2ARZ-R7 Datasheet - Page 4

• Manufacturer Part Number: ADA4062-2ARZ-R7
• Description: Dual36vLowPwrLowCostJFETInputAmp
• Manufacturer: Analog Devices Inc

Specifications of ADA4062-2ARZ-R7

• Design Resources: 8-Pole Active Low-Pass Filter Optimized for Precision, Low Noise, and High Gain Using AD8622 and ADA4062-2 (CN0127)
• Amplifier Type: J-FET
• Number Of Circuits: 2
• Slew Rate: 3.3 V/µs
• Gain Bandwidth Product: 1.4MHz
• Current - Input Bias: 2pA
• Voltage - Input Offset: 750µV
• Current - Supply: 165µA
• Current - Output / Channel: 20mA
• Voltage - Supply, Single/dual (±): 8 V ~ 36 V, ±4 V ~ 18 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Output Type: -
• -3db Bandwidth: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ADA4062-2
ABSOLUTE MAXIMUM RATINGS
Table 3.
Parameter
Supply Voltage
Input Voltage
Differential Input Voltage
Output Short-Circuit Duration to GND
Storage Temperature Range
Operating Temperature Range
Junction Temperature Range
Lead Temperature (Soldering, 60 sec)
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
Rating
±18 V
±V
±V
Indefinite
−40°C to +125°C
−65°C to +150°C
−65°C to +150°C
300°C
SY
SY
Rev. 0 | Page 4 of 20
THERMAL RESISTANCE
θ
soldered in a circuit board for surface-mount packages. It was
measured using a standard 2-layer board.
Table 4. Thermal Resistance
Package Type
8-Lead SOIC
8-Lead MSOP
POWER SEQUENCING
The op amp supply voltages must be established simultaneously
with, or before, any input signals are applied. If this is not
possible, the input current must be limited to 10 mA.
ESD CAUTION
JA
is specified for the worst-case conditions, that is, a device
θ
158
210
JA
θ
43
45
JC
Unit
°C/W
°C/W