MAX2205EVKIT+ Maxim Integrated Products, MAX2205EVKIT+ Datasheet - Page 2

• Manufacturer Part Number: MAX2205EVKIT+
• Description: RF Modules & Development Tools MAX2205 EVAL KIT MAX2205 EVAL KIT
• Manufacturer: Maxim Integrated Products

Specifications of MAX2205EVKIT+

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

The MAX2205–MAX2208 EV kits are fully assembled and
factory tested. Follow the instructions in the Connections
and Setup section for proper device setup.
This section provides a step-by-step guide to operating
the EV kits and testing the devices’ functions. Do not
turn on DC power or RF signal generators until all con-
nections are made:
1) Set the SHDN jumper (JU1) on the EV kit to ON. This
2) Connect a DC supply set to +2.85V (through a DMM,
3) Connect the output (J3) to a DMM to measure output
4) Set the signal generator output to +15dBm,
5) Connect the signal generator to the SMA connector.
6) Turn on the DC supply; the supply current should
7) Activate the signal generator. The output voltage
MAX2205–MAX2208 Evaluation Kits
2
enables the device.
if desired) to the V
kit. If available, set the current limit to 10mA. Do not
turn on the supply.
voltage.
f = 800MHz. For the MAX2206, use a CW input from
the signal generator to the RF input. For the MAX2207,
use a TDMA input. For the MAX2205/MAX2208, use a
CDMA input. Using the power meter, determine the
actual power output of the signal generator. Use this
value to determine proper operation of the part.
Do not turn on the signal generator.
read approximately 3.5mA (MAX2206) or 2mA
(MAX2205/MAX2207/MAX2208), depending on the
part being tested.
should read approximately +1.8V for the MAX2206/
MAX2207/MAX2208, or +0.25V for the MAX2205.
_______________________________________________________________________________________
Connections and Setup
CC
and GND terminals on the EV
Quick Start
Signal Generator with
Digital Modulation
Capabilities
Power Meter
Power Supply
Digital Multimeters
(DMMs)
EQUIPMENT
Test Equipment Required
Capable of delivering
continuous wave (CW), CDMA,
and TDMA signals with
+15dBm output power
To accurately measure the
power into the RF input
Capable of up to 10mA at
+2.7V to +6V
To measure output voltage and
supply and output current
DESCRIPTION