215464-4 TE Connectivity, 215464-4 Datasheet - Page 15

• Manufacturer Part Number: 215464-4
• Description: CONNECTOR, 4WAY, VERTICAL, 1.27
• Manufacturer: TE Connectivity
• Type: FFC Connectorr
• Series: Micro-MaTchr

Specifications of 215464-4

• Contact Gender: M
• Mounting Style: Through Hole
• Number Of Contact Rows: 2
• Number Of Contacts: 4POS
• Pitch (mm): 2.54mm
• Body Orientation: Straight
• Contact Resistance Max: 10mOhm
• Operating Temp Range: -40C to 105C
• Housing Material: Polyester
• Housing Color: Red
• Contact Material: Phosphor Bronze
• Contact Plating: Tin Over Nickel
• Termination Method: Solder
• Product Height (mm): 7.1mm
• Product Depth (mm): 5mm
• Connector Type: Wire-to-Board
• Gender: Plug
• Lead Spacing: 1.27mm
• No. Of Rows: 2
• No. Of Ways: 4
• Rohs Compliant: Yes
• Product Type: Plugs - PCB
• Pitch: 1.27 mm
• Number Of Positions / Contacts: 4
• Number Of Rows: 2
• Mounting Angle: Vertical
• Termination Style: Solder Pin
• Wire Gauge Range: 28
• Voltage Rating: 230 V
• Current Rating: 1.5 A
• Type Of Connector: Male-On-Board
• Mount Angle: Vertical
• Pcb Mount Style: Through Hole
• Polarization: With
• Number Of Positions: 4
• Centerline (mm [in]): 1.27 [0.050]
• Contact Base Material: Phosphor Bronze
• Contact Plating, Mating Area, Material: Tin
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Printed Circuit Board
• Packaging Method: Reel
• Packaging Quantity: 2,500
• Lead Free Status / RoHS Status: Compliant

.
QUALITY ASSURANCE PROVISIONS
4.1
4.1.1
Samples shall be released in accordance with applicable instruction sheets. They shall be selected at
random from production. At least 5 connectors of the 6 positions or at least 30 contacts shall be used for
each testgroup.
4.1.2
Qualification inspection shall be verified by testing samples as specified in spec. 108-19052 Par 3.7.
4.2
If changes significantly affecting form, fit or function are made to the product or the manufacturing
process, product assurance shall co-ordinate requalification testing, consisting of all or part of the original
testing sequence as determined by development/product, quality and reliability engineering.
4.3
Acceptance is based on verification that the product meets the requirement of par 3.6. Failures attributed
to equipment, test set-up or operator deficiencies shall nor disqualify the product. When product failure
occurs, corrective action shall be taken and samples resubmitted to qualification. Testing to confirm
corrective action is required before submittal.
4.4
The applicable AMP quality inspection plan will specify the samples acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with applicable product drawing and this
specification.
Rev. F
R6-77 (Rev. 07-01)
Sample selection:
Test sequence
Qualification testing:
Requalification testing
Acceptance.
Quality Conformance Inspection
Page 15 of 15
108-19052