0638190200 Molex Inc, 0638190200 Datasheet - Page 6

• Manufacturer Part Number: 0638190200
• Description: HAND CRIMP TOOL
• Manufacturer: Molex Inc

Specifications of 0638190200

• Lead Free Status / RoHS Status: RoHS Not Applicable

Hand Crimp Tool For C-Grid III™ Female Crimp Terminals
Doc No: ATS-63819-0200 Release Date: 11-02-07
Revision: A
Warranty
2. Rotate the setting wheel counter-clockwise (CCW) to increase handle force. The numbers will display higher.
3. Release the link to lock the setting wheel in place.
4. Check the crimp specifications or
This tool is for electrical terminal crimping
purposes only. This tool is made of the
best quality materials. All vital
components are long life tested. All tools
are warranted to be free of manufacturing
defects for a period of 30 days. Should
such a defect occur, we will repair or
exchange the tool free of charge. This
repair or exchange will not be applicable
to altered, misused, or damaged tools.
This tool is designed for hand use only.
Any clamping, fixturing, or use of handle extensions voids this warranty.
CAUTIONS:
1. Manually powered hand tools are intended for low volume or field repair. This tool is
2. Insulated rubber handles are not protection against electrical shock.
3. Wear eye protection at all times.
4. Use only the Molex terminals specified for crimping with this tool.
Certification
Molex does not certify or re-certify hand tools but rather supplies the following guidelines for customers to re-certify
hand tools.
%
%
%
To decrease handle force rotate the setting wheel clockwise (CW).
conduct a pull test after tool handle
preload force is adjusted.
production use. Repetitive use of this tool should be avoided.
This tool is qualified to pull force only. To re-certify, crimp a terminal to a wire, which has been stripped
12.7mm (1/2”) long, so there is no crimping of the insulation. Pull the terminal and wire at a rate no faster than
25mm (1.00”) per minute. See the Molex web site for the Quality Crimp Handbook for more information on pull
testing.
If the tool does not meet minimum pull force values, handle preload should be increased and the pull test
rerun, (See How to Adjust Preload).
When the hand tool is no longer capable of achieving minimum pull force, it should be taken out of service and
replaced.
CAUTION: Molex crimp specifications are valid only when used with Molex terminals and tooling.
Revision Date: 11-02-07
SETTING
WHEEL
UNCONTROLLED COPY
RELEASE LEVER
RATCHET
THE HANDLE
THE LINK IN
SQUEEZE
NOT
intended for
Figure 12
TOOL IN POSITION
HOLD THE HAND
Page 6 of 7