1490413-1 TE Connectivity, 1490413-1 Datasheet - Page 5

• Manufacturer Part Number: 1490413-1
• Description: Tools, Hydraulic Crimp
• Manufacturer: TE Connectivity
• Type: Dier

Specifications of 1490413-1

• Crimp Tool: Hydraulic Hand
• Connector Type: Crimp
• Rohs Compliant: NA
• Product: Tool Component
• Lead Free Status / RoHS Status: RoHS Not Applicable
• For Use With: Interchangeable Dies
• Lead Free Status / Rohs Status: RoHS Exempt Product

5.3. Periodic Inspection
Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
should remain with the dies or be made available to
supervisory personnel responsible for the dies.
Though recommendations call for at least a monthly
inspection, the inspection frequency should be based
upon the amount of use, working conditions, operator
Rev E
Sight
Hole
Stamped Here
1
2
3
4
5
Wire Range
3. When dies are not in use, make certain all
surfaces are protected with a THIN coat of any
good SAE 20 motor oil, and mate and store them
in a clean, dry area.
Crimps centered. Crimps may be off center BUT NOT OFF
END OF WIRE BARREL.
AWG wire size being used matches wire range or size
stamped on terminal or splice and dies.
Insulation does not enter wire barrel.
Wire is visible through inspection hole of butt splices. Wire is
flush with or extends slightly beyond end of terminal wire
barrel.
On parallel splices, bare wire ends must be flush with
or extended slightly beyond end of barrel.
or
Wire Range
Stamped
Under Tongue
Standard
Type
4
3
2
3
1
4
Terminal
2
1
1
Strap
Type
ACCEPT
3
3
1
Tyco Electronics Corporation
5
Butt Splice
Figure 6
Terminal
Parallel
Splice
training and skill, and established company
standards. These inspections should be performed in
the following sequence:
A. Visual Inspection
1. Remove all lubrication and accumulated film by
immersing the dies in a suitable degreaser that will
not affect paint or plastic.
2. Check all surfaces for wear. Inspect the crimp
area for flattened, chipped, cracked, worn, or
broken areas. If damage is evident, the die must
be replaced.
1
2
3
4
5
6
Crimped off end of splice or terminal wire barrel.
AWG wire size being used does not match wire size or
range stamped on terminal or splice and dies.
Insulation entered barrel of terminal or splice. CHECK
FOR INCORRECT STRIP LENGTH.
Wire not inserted far enough in terminal or splice. End of
wire must be visible through inspection hole of butt splices,
and be flush with or extend slightly beyond end of terminal
wire barrel or parallel splice.
Excessive “flash” on terminal or splice indicates damaged
dies or wrong wire, splice, or tooling combination was used.
Nicked or missing strands.
Stamped Here
Wire Range
REJECT
6
4
(Figure 7)
1
3
2
Terminal
Wire Range
Stamped
Under Tongue
5
4
4
1
1
4
5 of 7
2
3