TOTX147LF,T Toshiba, TOTX147LF,T Datasheet - Page 4

• Manufacturer Part Number: TOTX147LF,T
• Description: Fiber Optic Transmitters, Receivers, Transceivers Toslink Transmitter 15Mbps Vcc=3.3V
• Manufacturer: Toshiba

Specifications of TOTX147LF,T

• Product: Transmitter
• Wavelength: 650 nm
• Operating Supply Voltage: 2.7 V to 3.6 V
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: - 20 C
• Optical Fiber Type: TX
• Data Transfer Rate: 15Mbps
• Operating Temperature Classification: Commercial
• Peak Wavelength: 650nm
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (typ): 3V
• Operating Supply Voltage (max): 3.6V
• Operating Temp Range: -20C to 70C
• Mounting: Snap in
• Pin Count: 3
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

(6)
(7)
(8)
(9)
(10) Soldering condition
(11) The hole for chassis
(12) Case(receptacle) material
Panel attachment
TOTX147L(F,T) has hole for panel attachment. Please be sure to attach it to panel with self−tapping
screw.
Solvent
When using solvent for flux removal, do not use a high acid or high alkali solvent. Be careful not to
pour solvent in to the optical connector ports. If solvent is inadvertently poured in to them, clean it off
using cotton tips.
Supply voltage
Use the supply voltage within the recommended operating condition (V
that supply voltage does not exceed the maximum rating value of 4.5 V, even for an instant.
Input voltage
If a voltage exceeding the maximum rating value (V
the internal IC may suffer damage. If there is a possibility that excessive voltage due to surges may
be added to the input terminal, insert a protective circuit.
Solder at 260°C or less for no more than ten seconds.
Please make a hole for inserting optical connector
the slash part in the following figure.
The case is made of polycarbonate. Polycarbonate is usually stable with acid, alcohol, and
aliphatic hydrocarbons however, with petrochemicals (such as benzene, toluene, and acetone),
alkali, aromatic hydrocarbons, or chloric hydrocarbons, polycarbonate becomes cracked, swollen,
or melted. Please take care when choosing a packaging material by referencing the table below.
〈Chemicals to avoid with polycarbonate〉
A
B
C
D
Little deterioration
But staining
Cracked crazed,
Melted
｛ ｝ ：used as solvent
Decomposed
or Swollen
PHENOMENON
・nitric acid(low concentration) , hydrogen peroxide, chlorine
・acetic acid(70% or more)
・gasoline
・methyl isobutyl ketone, ethyl acetate, butyl acetate
・methyl methacrylate, ethyl ether, MEK
・acetone, m-amino alcohol, carbon tetrachloride
・carbon disulfide, trichloroethylene, cresol
・thinners, oil of turpentine
・triethanolamine
・concentrated sulfuric acid
・benzene
・styrene, acrylonitrile, vinyl acetate
・ethylenediamine, diethylenediamine
・{chloroform, methyl chloride, tetrachloromethane, dioxane}
・ammonia water
・other alkali
{1,2-dichloroethane}
4
CC
+ 0.5 V) is applied to the transmitters' input,
CHEMICALS
CC
= 2.7 to 3.6 V). Make sure
TOTX147L(F,T)
2005-06-20