ENW-C9A25A1EF Panasonic - ECG, ENW-C9A25A1EF Datasheet - Page 21

• Manufacturer Part Number: ENW-C9A25A1EF
• Description: RF MODULE 802.15.4 W/ANT NO SW
• Manufacturer: Panasonic - ECG
• Series: PAN4561r

Specifications of ENW-C9A25A1EF

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4
• Applications: General Purpose
• Power - Output: 10dBm
• Sensitivity: -102dBm
• Voltage - Supply: 2.7 V ~ 3.4 V
• Current - Receiving: 47mA
• Current - Transmitting: *
• Data Interface: PCB, Surface Mount
• Memory Size: 60kB Flash, 4kB RAM
• Antenna Connector: On-Board, Chip
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: ENWC9A25A1EF

CLASSIFICATION
SUBJECT
CUSTOMER’S CODE
PAN4561H /M /L
PANASONIC ELECTRONIC DEVICES EUROPE GMBH
22.3.
(4)
(5)
(6)
(7)
(8)
(9)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
USAGE CONDITIONS NOTES
If a vinyl-covered wire comes into contact with the products, then the cover will
melt and generate toxic gas, damaging the insulation. Never allow contact
between the cover and these products to occur.
This product should not be mechanically stressed or vibrated when reflowed.
If you want to repair your board by hand soldering, please keep the conditions of
this chapter.
Please do not wash this product.
Please refer to the recommended pattern when designing a board.
Pressing on parts of the metal cover or fastening objects to the metal will cause
damage to the unit.
Please take measures to protect the unit against static electricity.
If pulses or other transient loads (a large load applied in a short time) are applied
to the products, check and evaluate their operation befor assembly on the final
products.
Please do not use dropped products.
Please do not touch, damage or place dirt on the pins.
Please follow the recommended condition ratings about the power supply
applied to this product.
Electrode peeling strength: Do not add pressure of more than 4.9N when
soldered on PCB.
Pressing on parts of the metal cover or fastening objects to the metal cover will
cause damage.
These products are intended for general purpose and standard use in general
electronic equipment, such as home appliances, office equipment, information
and communication equipment.
MODEM FOR 802.15.4 IEEE STANDARD
PRODUCT SPECIFICATION
PANASONIC PART NUMBER
ENWC9A22xxEF / .25xx. / .21xx.
No.
DS-4561-2400-102
PAGE
DATE
www.pedeu.pansonic.de
06.08.2010
21 of 34
REV.
G