19-01F-3-TGG MULTICOMP, 19-01F-3-TGG Datasheet - Page 2

• Manufacturer Part Number: 19-01F-3-TGG
• Description: PLUG, SMA, STRAIGHT, CLAMP, RG58
• Manufacturer: MULTICOMP

Specifications of 19-01F-3-TGG

• Coaxial Termination: Clamp
• Rg Cable Type: RG-58
• Contact Material: Brass
• Contact Plating: Gold
• Connector Mounting: Cable Mount
• Cable Type: 58
• Connector: RoHS Compliant
• Connector Type: SMA, Coaxial
• Impedance: 50ohm

This data sheet and its contents (the "Information") belong to the Premier Farnell Group
(the "Group") or are licensed to it. No licence is granted for the use of it other than for
information purposes in connection with the products to which it relates. No licence
of any intellectual property rights is granted. The Information is subject to change with-
out notice and replaces all data sheets previously supplied. The Information supplied is
believed to be accurate but the Group assumes no responsibility for its accuracy or
completeness, any error in or omission from it or for any use made of it. Users of this
data sheet should check for themselves the Information and the suitability of the prod-
ucts for their purpose and not make any assumptions based on information included or
omitted. Liability for loss or damage resulting from any reliance on the Information or
use of it (including liability resulting from negligence or where the Group was aware of
the possibility of such loss or damage arising) is excluded. This will not operate to limit
or restrict the Group's liability for death or personal injury resulting from its negligence.
SPC MULTICOMP is the registered trademark of the Group. © Premier Farnell plc 2007.
Specifications:
Bodies
Centre Contact
Insulation
Connector interface per MIL-STD-348A.
Part to be clean and free of burrs.
Specification Table
Number
10
11
1
2
3
4
5
6
7
8
9
: Brass per JIS-C3604.
: Brass per JIS-C3604.
: PTFE per ASTM D1457 and ASTM D1710.
Centre Contact
Description
Braid Clamp
Insulation II
Insulation I
Washer
Washer
Gasket
Gasket
Shell
Body
Nut
PART NO.
TOLERANCES:
UNLESS OTHERWISE
SPECIFIED,
DIMENSIONS ARE
FOR REFERENCE
PURPOSES ONLY.
19-01F-3-TGG
Stainless Steel
Material
Silicone
Silicone
Brass
Brass
Brass
Brass
Brass
PTFE
PTFE
DRAWN BY:
Nirosha
CHECKED BY:
Suresh
APPROVED BY:
G.Cook
Gold 50µ’’ Minimum
Gold 3µ’’ Minimum
Gold 3µ’’ Minimum
Gold 3µ’’ Minimum
Gold 3µ’’ Minimum
Finish
ECN # REV
None
None
None
Red
Red
-
13/09/07
13/09/07
18/09/07
A
DATE:
DATE:
DATE:
DRAWING TITLE:
SIZE
SCALE: NTS
A
19-01F-3-TGG
REVISIONS
Part Number
DESCRIPTION
DWG NO.
RELEASED
M10000478
U.O.M.: mm (Inches)
DRAWN
Nirosha 13/09/7
19-01F-3-TGG
DATE
CHECKD
http://www.farnell.com
http://www.newark.com
http://www.cpc.co.uk
Suresh
ELECTRONIC FILE
1169617_DWG
SHEET:
13/09/7
DATE
APPRVD
G. C
2
OF 2
18/9/07
DATE
REV
A