10-347 GC Electronics, 10-347 Datasheet - Page 5

• Manufacturer Part Number: 10-347
• Description: EPOXY 2 PART ADHESIVE, TUBE, 2FL.OZ
• Manufacturer: GC Electronics
• Type: Gluer

Specifications of 10-347

• Adhesive Type: Epoxy - 2 Part
• Color: Gray
• Dispensing Method: Tube
• Volume: 2fl.oz. (US)
• Chemical Component: Amorphous Silicon Dioxide/Bisphenol-A Type Epoxy Resin/Butyl Glycidyl Ether/Calcium Carbonate/Carbon Black
• Density, Vapor: Air
• Flash Point: +200
• Odor: Mild Epoxy
• Physical State: Paste
• Primary Type: Adhesive
• Specific Gravity: 1.3
• Standards: Complies with OSHA Hazard Communication Standard 29 CFR 1910.1200
• Time, Setting: 5 hrs.
• Weight: 2 fl.oz.
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

GC Electronics
Respiratory Protection:
Ventilation:
Protective Gloves:
Eye Protection:
Other Protective Equipment:
Hygenic Practices:
Handling and Storage:
Other:
DOT Proper Shipping Name:
Hazard Class or Division:
Packing Group Number:
Required Label:
Identification Number:
TSCA Status:
Proposition 65 Substances
(Components) known to the State of
California to cause cancer and/or
reproductive toxicity and subject to
warning and discharge requirements
under the “Safe Drinking Water and
Toxic Enforcement Act of 1986”:
na=not applicable
Part Number(s): 10-347
NA=Not Available
Section 8 – Special Protection Information
Avoid breathing vapors/mists. Use approved chemical/mechanical filters
designed to remove a combination of particulates and organic vapors in open and
restricted areas when ventilation does not meet the requirements of 29 CFR
1910.134. Use approved airline type respirators or hoods in confined areas.
Sufficient ventilation in pattern and volume to keep the air contaminant
concentration below applicable exposure limits. All application areas should be
ventilated in accordance with OSHA regulation 29 CFR 1910.134.
Use neoprene or other impervious gloves to prevent skin contact.
Use safety glasses with side shields as minimum protection.
Use protective cream if skin contact is likely. Remove and wash contaminated
clothing before reuse. Discard contaminated shoes.
Wash hands before eating, smoking or using toilet facilities. Do not smoke in
any chemical handling and storage area. Food or beverage should not be
consumed anywhere near where this product is handled or stored.
Do not store near heat or open flame.
Empty container should not be reused.
Not Regulated
NA
NA
None
NA
All components of this product are listed on, or exempted from the requirement
to be listed on, the TSCA inventory.
None
Section 10 – Regulatory Information
ND=Not Determined
NE=Not Established
Section 9 – Special Precautions
mppcf=million parts/ft3
mg/M3=milligrams per cubic meter
Product Name: Epoxy Glue, Part B
MSDS Number: 133B
Page 3 of 4