10-150 GC Electronics, 10-150 Datasheet - Page 3

• Manufacturer Part Number: 10-150
• Description: SILICONE ADHESIVE, TUBE
• Manufacturer: GC Electronics
• Type: Sealantr

Specifications of 10-150

• Color: Clear
• Dispensing Method: Tube
• Chemical Component: Amorphous/Ethyltriacetoxysilane/Methyltriacetoxysilane/Silica
• Primary Type: Adhesive
• Temperature, Rating: 0 to +400 °F
• Time, Setting: 10 min.
• Weight: 3 fl.oz.
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

GC Electronics
Flash Point :
Auto-ignition:
Flammability Limits in air:
Comments N.D.:
Extinguishing Media:
Special Fire and Explosion
Procedures:
Unusual Fire and Explosion
Hazards:
Hazardous Decomposition
Products:
Acute Effects of Overexposure:
Eye:
Skin:
Inhalation:
Oral:
Comments:
The above listed potential effects of overexposure are based on actual data, results of studies performed upon similar
compositions, component data and/or expert review of the product. Overexposure to any chemical may result in
enhancement of pre-existing adverse medical conditions and allergic reactions.
First Aid Measures:
Eye:
Skin:
Inhalation:
Oral:
Comments:
Part Number(s):10-150, SD-151
Section 4 - Fire & Explosion Hazard Data
Immediately flush with water for 15 minutes. Get medical attention.
Remove from skin and wash thoroughly with soap and water or waterless
cleanser. Get medical attention if irritation or other ill effects develop
or persist.
Remove to fresh air. Get medical attention if ill effects persist.
No first aid should be needed.
None.
Direct contact irritates slightly with redness and swelling.
A single short exposure (less than 24 hours) may irritate. Repeated or
prolonged contact (24 to 48 hours) may cause irritation moderately.
Vapor overexposure may irritate eyes, nose and throat.
Small amounts transferred to the mouth by fingers during use, etc., should not
injure. Swallowing large amounts may cause digestive discomfort.
No injury from dusts should occur during reasonable use. If use creates
respirable particles, some respiratory system injury may occur. Cured sealant is
nonhazardous.
Section 5 - Health Hazard Data
Not applicable
Not determined
Lower: N/D
Product is considered a solid for DOT purposes and flash point is not
applicable.
Water fog, dry chemical, foam, CO
Self contained breathing apparatus and protective clothing should be
worn in fighting large fires involving chemicals.
None known
Thermal breakdowns of this product during fire or very high heat
conditions may evolve the following hazardous decomposition
products: Silicon dioxide. Carbon dioxides and traces of incompletely
burned carbon compounds. Formaldehyde
Upper: N/D
Product Name:Silicone Rubber
2
.
MSDS Number:149
Page 2 of 6