EB194 MATRIX, EB194 Datasheet - Page 6
![MULTI PROGRAMMER KIT, AVR, ATMEL](/photos/24/19/241992/138138907-40_sml.jpg)
EB194
Manufacturer Part Number
EB194
Description
MULTI PROGRAMMER KIT, AVR, ATMEL
Manufacturer
MATRIX
Datasheet
1.EB194.pdf
(14 pages)
Specifications of EB194
Mcu Supported Families
Atmel AVR
Programmer Type
Multiprogrammer
Development Tool Type
AVR Multiprogrammer
Tool / Board Application
Programming / Developing
Tool / Board
RoHS Compliant
Ic Product Type
In-Circuit Programmer
Features
E-Blocks Compatible, Low Cost, Used As A Programmer And As A Development Board, 4 Full I/O Ports
Rohs Compliant
Yes
4.3
Testing the Atmel AVR® Board – 90S1200.hex
The following instructions explain the steps to test and use your Atmel AVR® Board.
instructions assume that AVR® Studio is installed and functional. It also assumes that the test
program 90S1200.hex has been downloaded. This test routine is a step-by-step guide to loading a
programming into the Atmel AVR® Board.
Follow these instructions to test the Atmel AVR® Board
This should satisfy that the Atmel AVR® Board is fully functional!
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
11)
12)
13)
Programming the AT90S1200
Ensure power is supplied to all the Atmel AVR® Board via the power connector J4.
Insert EB-004 LED board into Port B of the Atmel AVR® Board
Ensure that the Almel AVR® is in correct configuration for programming
-
-
AVRISP connected to PC and J3 of AVR Board
Open AVR studio Software
Cancel the pop-up window to open any project / files
Click on the AVR programming symbol
Select AT90S1200 device form “Device” pop-down window
Select the “…” button in the Flash section as shown below
Navigate to the program 90S1200.hex
Press the program button. This will program the AT90S1200 with the test program
90S1200.hex
Press the “RESET” button (PB1) on the AVR Board
Check the illumination of all LEDs
Jumper links for J9, J10 and J11 are in the position marked “DEFAULT”
Ensure that a 11.052MHz crystal is inserted in the Atmel AVR® Board
-
-
Connect RS232 style cable (cable provided) to PC and to AVRISP box (grey
box)
Connect grey header socket (6-way) to J3 of AVR Board
Ensure the cable is placed with the tab to the outside of the AVR board (this
orientation of the header is shown on the AVR Board silk screen)
For details on AVRISP connector see ‘Programming – Hardware’ in chapter 5
Copyright © 2004 Matrix Multimedia Limited
Matrix Multimedia Atmel AVR® Board
EB19430
Page 6
The