013-0004 MULTICOMP, 013-0004 Datasheet

Metallised Shielding Bags Buried Metal - Gripseal Closure

· Available in various sizes

· Also available in open top style.

Disclaimer

in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied.

The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, a ny error in or omission from it or for any use made of it. Users of this data

sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assump tions based on information included or omitted. Liability for loss or damage

resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group w as aware of the possibility of such loss or damage arising) is excluded.

This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. SPC Multicomp is the registered trademark of the Group. © Premier Farnell plc 2008.

Conductive buried aluminium shielding layer between

two polymeric plastic layers:

exposed surface static dissipative.

Contains no amines, amides or n-octanoic acid.

Yield (per pound) 8,750sq.in

Total Thickness 3.1 mils (80 micron)

Tensile Strength: (ASTM D 882-91, Method A) MD: 5800 psi TD: 6600 psi

Tear Strength (D 1004-66 Notched) MD: 2.5lbs TD: 85%

Elongation (ASTM D 882-91, Method A) MD: 80% TD: 85%

Burst Strength (FTMS 101 C, Method 2007 la) 50 psi

Puncture Strength (FTMS 101C, Method 2065.1) >12lbs

Heat Seal Strength (D1876-93) Vertod bar sealer/heat & dwell 5.5 >14lbs/in width (room temperature)

MVTR (ASTM F-1249 @ 100oF/100 sq in/24hrs 0.3gms – nominal

Light Transmission (ASTM D-1003-92) 40% +/- 5%

ELECTRICAL PROPERTIES:

EMI Shielding (mili-B-81705C) >10dB Between 1 & 10 GHZ

Resistivity – Conductive Metal Layer (ASTM D-257) <50 ohms/sq. (5 x 101 ohm/sq)

Capacitive Probe Test (high Voltage Discharge) – (EIA – Std 541/Appendix E – 1KV) <20 volts

Static Decay (FTMS 101C, Method 4046.1, 5000 to O volts) <.0.03 Seconds

Surgace Resistivity (both surfaces) – (ESO11.11 @ 12% R.H.) <1012 ohms/sq (1010 ohm/sq typical)

Material Structure

1. Static Dissipative Layer

2. Polyester

3. Aluminimum Shielding Layer

4. Static Dissipative Polyethylene

PHYSICAL PROPERTIES:

Charge Generation – nominal (Modified incline plane average nC/sq.in) Teflon: - 0.09 Quartz: +0.10

http://www.farnell.com

http://www.newark.com

http://www.cpc.co.uk

This data sheet and its contents (the "Information") belong to the Premier Farnell Group (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes

/////////////////////////////////////////////

/////////////////////////////////////////////

//////////////////////////////////////////////

//////////////////////////////////////////////

P

a

g

e

<

1

>

2

2

1 /

0

0 /

8

V

1

1 .