KLABKIT KEENE ELECTRONICS, KLABKIT Datasheet - Page 2

• Manufacturer Part Number: KLABKIT
• Description: AMPLIFIER, IN-WALL, WITH PSU
• Manufacturer: KEENE ELECTRONICS

Specifications of KLABKIT

• Rohs Compliant: NA

Installation continued..
8. Connect the input signal cables using tinned cable. Connect the screens to the 2 centre connections
and the 2 signal wires (centre cores) to the top and bottom connectors. Note all the connectors are of the
superior rising clamp style so that they make a sound connection without biting through the copper of the
cable. Also supplied is a short cable with phono line sockets to open end that can be used to provide
trailing line sockets should you prefer.
9. Finally plug in the power supply. If using the recommended supply we suggest that it is hidden in the
cavity wall or another dummy pattress. The mains connection should be via a fused and switched
mains outlet such as order code SWL1 from Keene Electronics.
10. Double check all connections and, if all is well switch on. The red and blue LEDs will illuminate,
replace the faceplate and refer to the operating instructions.
11. The trimmer controls independently attenuate the left and right channels and may be used to
compensate for any imbalance in the input signal and to fine tune for loudspeaker placement. The default
is maximum for both channels.
12. Use in bathrooms etc, The unit is not IP rated for use in damp environments but if due care is given to
positioning of the mains supply and to water proofing of the amp (such as mounting behind a Perspex
panel or sealing the unit) then it should be capable of operating in such an environment. Please use a
qualified electrician operating to current regulations if you intend to use this unit in a bathroom.
Right
speaker
connection
terminal
DC power
input socket.
10-15vDC at
3.0A
Trimmers
for left and
right
channel
input
Input terminals
for line level
signal
Left speaker
connection
terminal