1485DS9 Hammond Manufacturing, 1485DS9 Datasheet - Page 3

• Manufacturer Part Number: 1485DS9
• Description: WIREWAY SEALING PLATE
• Manufacturer: Hammond Manufacturing

Specifications of 1485DS9

• Color: Gray
• Product: Rack Accessories
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

320
1485 Series Lay-In Wireway - NEMA 12
Application
•
•
Standards
•
•
•
Technical references and DXF downloads available at www.hammfg.com
© Hammond Manufacturing
Designed to enclose and protect
electrical wiring from dirt, dust, oil
and water.
All sections and fittings are
completely open on each side to
allow wires and cables to be placed
into the wireway without “pulling
through”.
UL 870 Type 1 (unless marked1)
CSA Type 1 (unless marked1)
Complies with
•
•
•
•
NEMA Type 12
JIC EMP-1-1967
JIC EGP-1-1967
IEC 60529, IP54
Canada: 519.822.2960 or 905.456.3770
Quality Enclosures. Service Excellence.
Construction
•
•
•
•
•
•
•
•
•
•
Bodies and covers are formed from
14-gauge steel with 10 gauge steel
flanges.
12” x 6” size has a 12 gauge steel
body with a 14-gauge cover.
Smooth continuously welded
seams.
Interior surfaces are smooth to
prevent wire damage during
installation.
Butt hinged cover is secured with
easily operated quick release
clamps.
Oil resistant gaskets are
permanently secured.
Solid oil resistant gaskets are used
between flanges when sections and
fittings are bolted together.
One gasket kit, complete with
hardware is provided with each
straight section or fitting.
Sealing plate is supplied.
Flange junctions are sealed with
gasket sealing plates, which are put
in place after wiring is completed.
One is supplied with all straight
sections and most fittings; see table
for exact number.
USA: 716.630.7030
All dimensions in inches unless specified otherwise
Finish
•
Notes
•
•
•
•
Sections and components are
finished in ANSI 61 gray powder
coating.
When joining a wireway section or
fitting to an enclosure be sure to
order a box connector.
When joining two wireway sections,
or joining a wireway section to a
fitting, a flat sealing plate is required
at each junction; necessary kits
are supplied with each section and
fitting. See table, extra kits may be
ordered if necessary.
When joining a lay-in wireway
section or fitting to a closure plate,
a box connector, or cut-off fitting,
an angle sealing plate is required at
each junction.
Necessary kits are supplied with
each section and fitting - see table.
Extra kits, although not normally
required, are necessary when
joining lay-in wireway to a non-lay-in
section or fitting section.
Data Subject to change without notice