D151 ETERNA, D151 Datasheet - Page 2

• Manufacturer Part Number: D151
• Description: LIGHT FITTING, CEILING, SLIM, 16W
• Manufacturer: ETERNA

Specifications of D151

• Light Source: 1 X 16W 2D 4 Pin
• Depth: 45mm
• Svhc: No SVHC (15-Dec-2010)
• Base Type: Double-D 4 Pin
• Colour: White
• External Depth: 45mm
• External Diameter: 295mm
• External Length / Height: 45mm
• External Width: 295mm

Safety markings:
Read this first:
>
>
>
>
>
>
>
>
>
>
If in any doubt, consult a qualified electrician.
Switch off the mains before commencing installation and remove
the appropriate circuit fuse.
Suitable for indoor use only.
This product is only suitable for use in living areas ( not for areas
constantly subject to moisture ).
This product is suitable for installation on surfaces with normal
flammability ( indicated by the "F" in a triangle ) e.g. wood,
plasterboard, masonry. It is not suitable for use on highly
flammable surfaces ( e.g. polystyrene, textiles ).
Before making fixing hole(s), check that there are no obstructions
hidden beneath the mounting surface such as pipes or cables.
The chosen location of your new fitting should allow for the product
to be securely mounted ( e.g. to a ceiling joist ) and safely
connected to the mains supply ( lighting circuit ).
Do not attach to surfaces which are damp, freshly painted or
otherwise electrically conductive (e.g. metallic surfaces).
If the location of your new fitting requires the provision of a new
electrical supply, the supply must conform with the requirements of
the latest edition of the IEE wiring regulations.
This product is designed for permanent connection to fixed wiring:
this should be either a suitable lighting circuit ( protected with a 5 or
6 Amp MCB or fuse ) or a fused spur ( with a 3 Amp fuse ) via a
fused connection unit. We recommend that the supply incorporates
a switch for ease of operation.
>
>
Installation:
1)
2)
3)
4)
5)
6)
7)
Make connections to the electrical supply in accordance with the
following code:
Additional red wires may be present in your ceiling that are
connected to the ring live circuit. Do not connect your fitting to
these wires. If these wires are not terminated in a ceiling rose, join
them together in a separate terminal block ( not supplied ), ensure
that there are no strands of wire protruding from the terminals and
wrap well with insulating tape.
This product must be connected to Earth.
Pull out the three clips to release the diffuser.
Thread your supply wiring through the large hole in the back of the
fitting.
Secure the fitting in place using the fixings supplied or, if these
fixings are not appropriate to your installation, select suitable
alternatives.
Make the electrical connections according to the colour code
above.
Fit the Energy saving square fluorescent lamp—4 pin ( supplied )
by pressing gently onto the socket in the centre of the fitting until it
clicks into place. If the tube does not fit easily, try rotating it through
180° and try again.
Replace the diffuser and push the clips back into position.
Restore the power supply and switch on.
Live - Brown or Red
Neutral - Blue or Black
Earth - Green and Yellow