BTEP-F570VGA-C-TP BATRON, BTEP-F570VGA-C-TP Datasheet - Page 23

• Manufacturer Part Number: BTEP-F570VGA-C-TP
• Description: DISP 5.7" TFT LCD DEV KIT
• Manufacturer: BATRON

Specifications of BTEP-F570VGA-C-TP

• Lcd Display Type: TFT
• Interface Type: RS232, USB
• Viewing Area (h X W): 88mm X 117mm
• Svhc: No SVHC (15-Dec-2010)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

11．Precautions for use
11-1. Installation of the LCD
10. This Kyocera LCD module has been specifically designed for use in general electronic devices,
11-2. Static Electricity
11-3. LCD Operation
11-4. Storage
1. The LCD's bezel must be grounded. The heat sink and shield cover are connected at the ground
2. A transparent protection sheet shall be added to protect the LCD and its polarizers.
3. The LCD shall be installed so that there is no pressure on the LSI chips.
4. The LCD shall be installed flat, without twisting or bending.
5. The display window size should be the same as the effective viewing area.
6. In case you use outside frame of effective viewing area as outward appearance of your product,
7. Please refer to the following our recommendable value of Clamp-down torque when installing.
8. A transparent protection sheet is attached to the polarizer. Please remove the protection
9. Do not pull the CFL lead wires and do not bend the root of the wires.
1. Since CMOS ICs are mounted directly onto the LCD glass, protection from static electricity is
1. The LCD shall be operated within the limits specified. Operation at values outside of these
2. Adjust "LCD driving voltage" to obtain optimum viewing angle and contrast.
1. The LCD shall be stored within normal temperature and humidity.
2. Always store the LCD so that it is free from external pressure onto it.
electric driver .
Conneted between heat sink
and signal GND.
hole. The ground hole is located on the right side of the LCD when viewed from the front.
The ground hole must be connected to an external ground.
unevenness of its outward appearance is out of guarantee.
Clamp-down torque:3.3±0.3kgf.cm Please set up'SPEED-LOW', 'SOFT START-SLOW' when using
Recommendable screw P-TITE screw nominal dia.3.0mm
installing boss hole depth 3.5±0.5mm
Please be careful not to use high torque which may damage LCD module in installation.
film slowly before use, paying attention to static electricity.
Housing should be designed to protect CFL lead wires from external stress.
but not for use in a special environment such as usage in an active gas.
Hence, when the LCD is supposed to be used in a special environment, evaluate
the LCD thoroughly beforehand and do not expose the LCD to chemicals such as an active gas.
required. Operator should wear ground straps.
limits may shorten life, and/or harm display images.
It may also change the characteristics of the liquid crystal.
This phenomenon may not recover. The LCD shall be operated within the temperature limits
specified.
Store in a dark area, and protected the LCD from direct sunlight or fluorescent light.
Initial state (GND connection)
Customer selection
Shield cover
Front bezel
Heat sink
PCB
Data Modul AG - www.data-modul.com
Ground hole
Front bezel, heat sink and shield cover are
connected at the ground hole, but please
connect the ground hole to the external ground
for enhancement.
① Bolt + Nut
② Bolt + Nut + Cable
22