PDSM362 TIMEGUARD, PDSM362 Datasheet - Page 2

• Manufacturer Part Number: PDSM362
• Description: PRSNCE DTCTR, PIR, SM, 2000W, 2 CH
• Manufacturer: TIMEGUARD

Specifications of PDSM362

• Beam Angle: 360°
• Base Type: Incandescent / Halogen
• External Depth: 121.5mm
• External Length / Height: 42.5mm
• External Width: 121.5mm
• Ip/nema Rating: IP40
• Power Rating: 2000W
• Sensing Distance Max: 7m
• Svhc: No SVHC (15-Dec-2010)
• Lamp Base Type: Incandescent / Halogen
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3
3.1 Select the required location
3.1.1 Sensor adjustment
Fig. 2 shows the way coverage alters with ceiling height and with
adjustments of the METER dial setting.
Section 4.2.3 shows how tilting and rotating the sensor can produce
different fields of coverage.
Side View
Ceiling Height (H)
If the METER control is turned to - the coverage diameter is substantially
reduced.
We do not recommend the use of these units with ceiling heights
greater than 4.5m.
3.1.2 Helpful tips for installation
As the sensor responds to temperature change or moving heat sources,
please avoid the following conditions:
• Avoid highly reflective surfaces within the detection range.
• Avoid movable objects e.g. curtains and plants in the detection range
• Avoid heat sources (e.g. heating vents, radiators, air conditioners and
• Avoid fans drawing air across the sensor lens.
3.2 Wiring
3.2.1 Lighting and HVAC are controlled by one PDSM362 (see Fig.3).
(these may cause erronious detections when moved by air flow from
fans or air conditioner).
filament lamps) in detection range.
Installation and Wiring
2m
2.5m
3m
3.5m
4m
4.5m
Please disconnect power completely and read the
entire instruction manual carefully before installation.
Detection Coverage Diameter (D)
Fig. 2
Fig. 3
Top View (showing individual
beam pattern at floor level)
with METER on +
7m
10m
12m
7m
12m
12m
3.2.2 Lighting is controlled by two PDSM362’s to enlarge detection
range (see Fig.4).
3.2.3 Lighting is controlled by a PDSM361 (see Fig. 5).
3.3 Installation procedure
3.3.1 Insert large flat blade screwdriver into the groove as shown each
side in turn and twist (see Fig. 6) to remove outer cover.
3.3.2 To separate bottom case from lens body force a small flat blade
screwdriver into the hidden gap shown partially exposed in Fig. 7 then
push screwdriver in towards centre and lever bottom case assembly
away from lens body pins.
3.3.3 Remove cardboard and screws used to assemble and fix the sensor
(see Fig. 8).
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8