RU-VDA4B RADIO DESIGN LABS, RU-VDA4B Datasheet - Page 2
![no-image](/images/no-image-200.jpg)
RU-VDA4B
Manufacturer Part Number
RU-VDA4B
Description
AUDIO VISUAL (AUDIO VIDEO)
Manufacturer
RADIO DESIGN LABS
Datasheet
1.RU-VDA4B.pdf
(2 pages)
RACK-UP
Model RU-VDA4
Video Distribution Amplifier
POWER CONNECTION: Connect a single-ended 24 Vdc power source to the +24 terminal. Connect the ground return from that
supply to the adjacent GND terminal. Power supply and circuit grounds are common.
FRONT PANEL CONNECTIONS
INPUT: Connect video input to the IN jack. If the input signal is to continue on to another piece of equipment which will terminate
the input, connect a cable to the LOOP OUT jack; connect the other end of this cable to the terminating equipment. If no loop
output is used, connect a 75 Ohm terminator to the LOOP OUT jack.
OUTPUT: Connect the coaxial cable to the desired output(s) on the RU-VDA4, and label them as desired.
GAIN ADJUSTMENT: Adjust the GAIN potentiometer for 1 Vp-p video level on your instrumentation. In the absense of test
equipment, the 1V VIDEO INTO TERMINATED LOAD LED may be used. First turn the gain counter-clockwise. Then advance the
GAIN clockwise until the 1V VIDEO INTO TERMINATED LOAD LED just illuminates.
TYPICAL PERFORMANCE
Input Impedance:
Gain Range:
Load Impedance:
Outputs (5):
Output Level:
Frequency Response:
Noise:
Output Isolation:
Differential Gain:
Differential Phase:
Connector Type:
Power Requirement:
Mounting:
Dimensions:
891-0056D
®
SERIES
Europe [NH Amsterdam] (++31) 20-6238 983; Fax: (++31) 20-6225-287
U.S.A. (800) 933-1780, (928) 778-3554; Fax: (928) 778-3506
Radio Design Labs Technical Support Centers
1 kΩ (Bridging, 75 Ohm Line)
75 Ohms
1 Loop Out from Input Signal
4 Amplified Outputs
1 V p-p (into 75 Ohm)
10 Hz - 10 MHz (+/- 0.2 dB)
< -70 dB (below 1 V p-p)
> 40 dB
0.1%
0.1 degree (measured at 10% and 90% APL)
BNC (shown), Phono or Type-F also available
24 to 36 Vdc @ 60 mA, Ground-referenced
Rack-mount using any one of several rack mount chassis accessories
or other mounting accessories listed in the short form catalog or product CD-ROM.
Height:
Length:
Depth:
-1 dB to +7 dB (adjustable)
1.7 in.
5.8 in.
2.0 in.
2.5 in.
3.0 in.
15.0 cm
4.3 cm
5.1 cm (case only)
6.4 cm (including barrier block)
7.7 cm (including barrier block and jacks)
Installation/Operation
EN55103-1 E1-E5; EN55103-2 E1-E4
Typical Performance reflects product at publication time
exclusive of EMC data, if any, supplied with product.
Specifications are subject to change without notice.