6VM4 Tyco Electronics, 6VM4 Datasheet - Page 3

• Manufacturer Part Number: 6VM4
• Description: MODULE POWER ENTRY UNFILT 6A 4V
• Manufacturer: Tyco Electronics
• Series: Mr

Specifications of 6VM4

• Connector Type: Receptacle, Male Pins - Module
• Mounting Type: Panel Mount, Screw Hole
• Connector Style: IEC 320-C14
• Number Of Positions: 3
• Current: 6A
• Voltage: 120V
• Termination Style: Quick Connect - .110" (2.8mm)
• Fuse Drawer: Included
• Features: Fuse Holder, Switch, Voltage Selector
• Gender: Plug
• Voltage Rating: 250VAC
• Current Rating: 6A
• Connector Mounting: Flange
• Termination Type: Quick Connect
• Mounting Style: Flange
• Filter Type: Power Entry
• Filtered: Yes
• Frequency: 50 Hz
• Leakage Current: 5 uA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 1609128-8; 3-1609128-3; 3-6609128-3; CCM1004

Dimensions are in inches and millimeters unless otherwise specified. Values in italics
are metric equivalents. Dimensions are shown for reference purposes only.
Specifications subject to change.
1 1
100V
0 0
2 2
230V
0 0
3 3
3 3
2 2
0 0
0 0
1 1
2 2
0 0
1 1
120V
240V
4 4
2 2
4 4
0 0
0 0
2 2
1. Remove power cord
2. Insert a pocket screwdriver at point “X” as shown
3.
4. When the fuse holder is installed in the single fuse position,
5. Install one (1) AG fuse or two (2) metric fuses (see below)
6. Replace fuse holder into housing
7. Swing and push to snap door back in place
Gently lift the entire door UP approximately 1/4"
Once lifted, the door will pivot on it’s hinges to expose
the fuse holder
apply the screwdriver as shown and gently lift up
Use screwdriver as shown, do not use fingers
When the fuse holder is installed in the dual fuse position,
it will normally release as soon as the door is opened
Install fuses on one side only, do not install
both G and metric fuses at the same time
Lift Up
BEFORE REPLACING FUSES
USE ONLY WITH
DISCONNECT POWER
250V FUSES
A
A
Insert Here
NOT here
“X”
Section A-A
(minimum)