H4CFC6DI Amphenol Industrial Operations, H4CFC6DI Datasheet

Page 1

Amphenol Assembly Instruction for the Helios H4 PV Connector Connectors must not be connected or disconnected under load! www.amphenol-industrial.com ...

Page 2

Amphenol Helios H4 components come pre-assembled and the caps are loose. And the whole connector will include the male side and female side. PV-100508-F – Female side Connector PV-100508-M – Male side Connector www.amphenol-industrial.com ...

Page 3

Amphenol 1. Assembly Instruction for the male side and female side connector 1.1 Strip cable .276 inches (9/32”) - (7mm) and be careful NOT to nick conductors. Amphenol specified strip tool can be used in this step. Adjust the striper ...

Page 4

Amphenol 1. Assembly Instructions for the male side connector and female side. 1.2 Insert striped cable into contact barrel and insure all conductor strands are captured in the contact barrel and the conductors are visible in the contact barrel observation ...

Page 5

Amphenol 1. Assembly Instructions for the male side connector and female side. 1.3 Crimp contact barrel by using the hex crimping die. See below figures. Crimped pin contact Amphenol specified crimping tool can be used in this step. Put the ...

Page 6

Amphenol 1. Assembly Instructions for the male side connector and female side. 1.4 Insert contact cable assembly into back of male and female connector. A “click” should be heard or felt when the contact cable assembly is seated correctly. PV-090508-F ...

Page 7

Amphenol 1. Assembly Instructions for the male side connector and female side. 1.5 Wrest the cap by using the torque to Amphenol specified wrench tool can be used in this step. Here 2 wrench tools are used, one is by ...

Page 8

Amphenol 2. Mate and separate Helios H4 connector 2.1 After wrest the cap tightly, align the 2 half connectors and mate them together by hand until a “click” is heard or felt. 2.2 When the separation of connector is necessary, ...