INFS-0210-DC1 NEWPORT ELECTRONICS, INFS-0210-DC1 Datasheet - Page 53

• Manufacturer Part Number: INFS-0210-DC1
• Description: Strain Gauge Meter
• Manufacturer: NEWPORT ELECTRONICS

Specifications of INFS-0210-DC1

• No. Of Digits / Alpha: 6
• Meter Range: 0mV To 100mV
• Digit Height: 13.7mm
• Power Consumption: 6W
• Operating Temperature Range: 0°C To +50°C
• Signal Input Type: 0 To 100mV Voltage
• Lead Free Status / RoHS Status: na

8.3.3 TO SELECT DECIMAL POINT POSITION (DEC PT)
The following is the procedure for selecting your decimal point position.
PRESS
‘MENU’
‘MIN’
‘MENU’
‘RESET’ ‘RESET’
Your meter is now calibrated. If you need to offset your zero reading on
your meter after calibration, you must proceed with the following steps:
THEN PRESS
(TO CHANGE DISPLAY
IF REQUIRED) SHOWS
‘MAX’
8-9
“RESET2”
UNTIL
“DEC PT”
“FFF.FFF”
“CNT BY”
then the
Measured
Value
COMMENTS
Press the ‘MENU’
button until the display
shows “DEC PT”.
Press the ‘MIN’
button and the display
will show “FFFFFF.”or
the previously selected
position. Press the
‘MAX’ button to select
the decimal point
position you require,
the meter displays the
previously selected
decimal point location
within the “F’s”
Press the ‘MENU’
button to store your
decimal point selec-
tion and the meter
will momentarily
display “STORED”
only if you have made
a change and then
“CNT BY”.
Press the
‘RESET’ button two
times. The display will
momentarily show
“RESET2” and then
will display the
currently measured
values.
Scaling to
Display
Engineering
Units
8