EPAX0600 Red Lion Controls, EPAX0600 Datasheet - Page 5

• Manufacturer Part Number: EPAX0600
• Description: Multifunction Meter
• Manufacturer: Red Lion Controls

Specifications of EPAX0600

• No. Of Digits / Alpha: 6
• Panel Cutout Height: 6.23"
• Panel Cutout Width: 23.79mm
• Signal Input Type: Count And Rate, Serial Slave, Timer
• Character Size: 4"
• Color: Red
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: Red Lion MPAXI000, MPAXC000, MPAXR000, MPAXCK00 And MPACTM00 MPAX Modules

capabilities of our PAX Series Intelligent Panel Meters. Therefore, you
will find the appropriate PAX information packed with the MPAX
Module. Simply follow the instructions to wire and program the display
for your application.
recommended to connect the primary AC power to the EPAX terminal
block, then jumper to the MPAX module.
EPAX PROGRAMMING
the unit does not have a programming keypad. Unit programming must be
accomplished by one of the following three methods:
Optional Programming Remote (EPAXPGM0)
3.0 WIRING AND PROGRAMMING THE DISPLAY
Once assembled, the EPAX and MPAX have all the same functions and
Note: Both the EPAX and the MPAX module require power. It is
The unit is a large display, designed to be remotely mounted. Therefore,
This optional programming remote
plugs into the EPAX through an
RJ12 connector and a 10 foot cable.
The buttons on the programming box
function the same as the PAX unit.
Simply program the EPAX exactly
as the PAX instructions indicate. The
programming box can be left
connected to the EPAX for future
programming changes or can be
disconnected and used to program
additional EPAX units.
RJ12 CONNECTOR ON BOTTOM OF UNIT
5
Rear Terminal Block
Optional Serial Programming
External normally open switches can be wired via the terminal block to allow
unit programming. A minimum of 3 switches would be required. Each
external switch must be wired between the key and the common terminal.
Like all PAX units, you can purchase an RS232 or RS485 Comms Card and
program the unit via Windows
EPAX TERMINAL BLOCK
®
based software programs.