ELC-GP04-03 EATON CUTLER HAMMER, ELC-GP04-03 Datasheet - Page 55
ELC-GP04-03
Manufacturer Part Number
ELC-GP04-03
Description
Graphics Panel
Manufacturer
EATON CUTLER HAMMER
Datasheet
1.ELC-GP04-03.pdf
(64 pages)
Specifications of ELC-GP04-03
No. Of Functions
10
Pixel Format
128 X 64
For Use With
ELC Logic Controllers
February 2007
Product Description
The Cutler-Hammer
nologies (IT.) DeviceNet Adapter
(D77D-DNA) from Eaton’s electrical
business has greatly increased the
functionality of IT. communicating
products, allowing monitoring and
control for IT. I/O and IT. motor control
devices. The adapter concentrates all
data from these devices into a single
DeviceNet node.
To simplify the configuration of the
D77D-DNA, a simple auto-configure
button press sets the system up for
default operation. This automatically
configures the DeviceNet I/O assem-
blies to the QCPort system devices.
The data from these devices is assem-
bled into a single input and output
message.
Application Description
In a typical DeviceNet Adapter applica-
tion, the D77D-DNA connects directly
to DeviceNet, and resides in a system
with IT. I/O and other communicating
motor controls. The data from these IT.
devices is assembled into a single
input and output message before
being presented to DeviceNet.
CA05001001K
Cat. No. D77D-DNA
®
Intelligent Tech-
For more information visit: www.EatonElectrical.ca
Features, Functions and Benefits
Standards and Certifications
Approvals
Table 81. Approvals/Certifications
Electrical/EMC
Other Approvals
Description
ESD Immunity (IEC 61000-4-2)
Radiated Immunity (IEC 61000-4-3)
Fast Transient (IEC 61000-4-4)
Surge (IEC 61000-4-5)
RF Conducted (IEC 61000-4-6)
Magnetic Field (IEC 61000-4-8)
Ingress Protection Code
Radiated and Conducted Emissions EN 5011 Class A
Agency Certifications
Communication to DeviceNet
consuming one DeviceNet MAC ID
Provides for control of all IT. com-
municating devices connected to
the gateway
Manually set to MAC ID and baud
rate; configuration using a software
application is not required for nor-
mal operation
Single button press auto configures
the gateway, setting up the system
for default operation
Advanced configuration using
CH Studio
Provides for backplane and inter-
connect cable connections to
QCPort
PLC, I/O & Communications Products
IT. Connect
Communication Adapters (D77D Series) — DeviceNet Adapter
Specification
± 8 kV air, ± 4 kV contact
10V/m 80 – 1,000 MHz, 80% amplitude modulation @ 1 kHz
± 2 kV supply and control, ± 1 kV communications
± 1 kV line-to-ground, ± 2 kV line-to-line
10V, .15 – 80 MHz
30A/m, 50 Hz
IP20
UL 508, CUL (CSA C22.2 No. 14), CE (Low Voltage Directive),
ODVA Conformance Tested
Provides one I/O DeviceNet message
representing all QCPort subscanned
devices
Two independent QCPort (commu-
nication) ports
Powered from QCPort
Isolated from DeviceNet
Status LEDs for DeviceNet, QCPort
and module health
Provides for configuration of QCPort
devices over DeviceNet
Small package size
DIN rail mountable
55