PAXCDS40 Red Lion Controls, PAXCDS40 Datasheet - Page 28
![Quad Setpoint Sourcing Open Collector Output Interface Card](/photos/21/37/213700/4551886_sml.jpg)
PAXCDS40
Manufacturer Part Number
PAXCDS40
Description
Quad Setpoint Sourcing Open Collector Output Interface Card
Manufacturer
Red Lion Controls
Specifications of PAXCDS40
Accessory Type
Quad Setpoint Sourcing Open Collector Output Interface Card
Accuracy
± 0.01% + 10 ms
Brand/series
PAX Series
Card Type
Quad Setpoint Sourcing Open Collector Output Card
Standards
cULus Listed, CSA Certified and CE Marked
For Use With
Red Lion PAX Digital Input Panel Meters
Lead Free Status / RoHS Status
na
analog output signal, an analog output plug-in card needs to be installed (See
Ordering Information). This section replaces the bulletin that comes with the
analog plug-in card. Please discard the separate literature when using the plug-
in card with the PAXI.
current output use terminals 18 and 19. Only one range can be used at a time.
6.8 MODULE 8 - A
6.9 MODULE 9 - F
Module 8 is the programming for the analog output parameters. To have an
Enter the analog output type. For voltage output use terminals 16 and 17. For
Select the display that the analog output is to follow:
Intensity Level
PAR
9-FCS
d-LEV
Display
PAXI O
= Counter A Value
= Counter B Value
= Counter C Value
using the arrow keys. The display will actively dim or
brighten as the levels are changed. This parameter also
appears in Quick Programming Mode when enabled.
DISPLAY INTENSITY LEVEL
Enter the desired Display Intensity Level (0-15) by
ANALOG ASSIGNMENT
Service Code
NLY
SELECTION
Factory
ANALOG TYPE
COdE
PAR
RANGE
0 to 20 mA
4 to 20 mA
0 to 10 V
8-AnA
Analog
Type
tYPE
Pro
ACTORY
NALOG
= Rate Value
= Minimum Value
= Maximum Value
Assignment
Analog
ASIN
PARAMETER MENU
PARAMETER MENU
O
S
UTPUT
ERVICE
Scale Value
Analog Low
28
AN-LO
corresponds to the low limit of the type selected.
counter or rate. The scale value can not be set to read values with more than 6
digits. Reverse acting output is possible by reversing the scaling values.
corresponds to the high limit of the type selected.
counter or rate. The scale value can not be set to read values with more than 6
digits. Reverse acting output is possible by reversing the scaling values.
factory settings and display
memory failure or corrupted data. Immediately press RST key and reprogram
the meter. If the meter is powered down again before pressing the RST key, the
existing dynamic data will not be overwritten.
Enter the display value within the selected Analog Assignment that
The decimal point is determined by the decimal point setting of the assigned
Enter the display value within the selected Analog Assignment that
The decimal point is determined by the decimal point setting of the assigned
Pressing the PAR and DSP keys at the same time on power-up will load the
P
O
ARAMETERS
PERATIONS
Analog High
Scale Value
AN-HI
RESTORE FACTORY DEFAULTS
ANALOG HIGH SCALE VALUE
ANALOG LOW SCALE VALUE
The meter will display
Press DSP key to return to the Display Mode. This will
overwrite all user settings with the factory settings.
Use the arrow keys to display
Pro
. This allows operation in the event of a
to
(
to
(
and then returns to
)
)
and press PAR.
.