RP-RM83F-38LR BANNER ENGINEERING, RP-RM83F-38LR Datasheet - Page 5

• Manufacturer Part Number: RP-RM83F-38LR
• Description: Heavy-Duty Emergency Stop Rope Pull
• Manufacturer: BANNER ENGINEERING
• Type: Safetyr

Specifications of RP-RM83F-38LR

• Ring Attachment: 38 Meter Max. Range
• Actuator Type: Latch
• Body Style: Rectangular
• Current, Rating: 50 mA
• Ip Rating: IP67
• Number Of Positions: 2
• Voltage, Rating: 10-30 VDC
• Lead Free Status / Rohs Status: RoHS Compliant part

Banner Engineering Corp. - Minneapolis, MN U.S.A. - www.bannerengineering.com - Tel: [phone]
Installing Models RP-RM83F-..LT and RP-RM83F-..LTE
These models have their own internal turnbuckle and clamp to tension the rope and to hold it in place. This
innovative design provides for quick and easy rope fixing and tensioning, and requires no external turnbuckle,
nor any additional clamp at the switch end of the rope.
To install the rope at the switch end, strip away several inches of the cable covering. Loosen the set screw
on the switch fitting, using a 4 mm hex wrench. Insert the cable into the center hole, and pull the cut end out
from the side hole. When the tension is correct, tighten the set screw to hold the rope firmly in place.
Tensioning the Rope (All Models)
After the rope span components are installed, apply tension to the rope until the arrows in the tensioning
indicator are centered on the line in the indicator window. This indicates sufficient rope tension. (Contacts
11/12 will close.)
Models RP-RM83F-..LR and RP-RM83F-..LRE: Turn the turnbuckle until the arrows are centered.
Models RP-RM83F-..LT and RP-RM83F-..LTE: Turn the shaft of the switch using a 17 mm wrench as shown,
until the arrows are centered.
Pull hard on the rope and reset the latch several times. If the arrows in the tensioning indicator window do
not return to the correct position (centered on the line in the window), further tighten or loosen the rope tension
as needed, then reset, until proper tension is shown.
*Closer, if possible
**Distance must allow necessary clearance to all mounting hardware.
Figure 3: Tightening the rope into
the internal turnbuckle (models
RP-RM83F-..LT and -..LTE)
Switch Model
75 m
38 m
Max. Total Length L1
37.5 m (123')
75 m (245')
Tension Indicator (All Models)
Too Little
Tension Shown
Between Pulleys L2
Max. Distance
3-5 m (10-15')
RP-RM83F-.. Heavy-Duty Rope Pulls
Proper Tension
Shown
Spring/Turnbuckle
Max. Distance to
150 mm (6")
L3*
Figure 4: Adjusting rope
tension (models
RP-RM83F-..LT and-..LTE)
Min. Distance Fitting
P/N 141245 rev. A 01/09
to Pulley L4**
150 mm (6")
5