T30UDPB BANNER ENGINEERING, T30UDPB Datasheet - Page 5

• Manufacturer Part Number: T30UDPB
• Description: Ultrasonic Sensor
• Manufacturer: BANNER ENGINEERING

Specifications of T30UDPB

• Sensing Range Min: 300mm
• Sensing Range Max: 2m
• Switching Frequency: 128kHz
• External Diameter: 40mm
• Operating Temperature Range: -20°C To +70°C
• Peak Reflow Compatible (260 C): No
• Output Type: Transistor
• Contact Rating: 100mA
• Leaded Process Compatible: No

Banner Engineering Corp.
www.bannerengineering.com • Tel: [phone]
•
Minneapolis, MN U.S.A.
U-GAGE
NOTE: All LED indicators momentarily go OFF when sensor changes state between
Signal LED
The red Signal LED indicates the strength and condition of the sensor’s incoming signal.
Output LEDs
Each yellow Output LED lights when a target is sensed within the programmed window
limits.
Power ON/OFF LED
The green Power ON/OFF LED indicates the operating status of the sensor.
In the unlikely event of a microprocessor memory error, all of the LEDs will flash in
sequence. If this occurs, the setup parameters have been lost and the sensor may be
corrupt. Contact your Banner representative for further information.
RUN Mode
OFF
Flashing
OFF
ON Solid
Flashing
Self-Diagnostic Error Mode
Power ON/OFF LED
Signal LED Status
PROGRAM and RUN modes.
™
T30 Series with Dual Discrete Outputs
No signal is received, or the target is beyond the range limitations
of the sensor (with some tolerance beyond the recommended
minimum and maximum sensing distance)
Relative received signal strength; the faster the LED flashes, the
stronger the signal
Power is OFF (or in PROGRAM mode, if other LEDs are ON)
Sensor is operating normally (power is ON, RUN mode)
Discrete output is overloaded (RUN mode)
Indicates
Indicates
P/N 59200 Rev. D
5