TG4C BOGEN COMMUNICATIONS, TG4C Datasheet - Page 2

TRANSDUCER, TONE GENERATOR, 48VDC

TG4C

Manufacturer Part Number
TG4C
Description
TRANSDUCER, TONE GENERATOR, 48VDC
Manufacturer
BOGEN COMMUNICATIONS
Datasheet

Specifications of TG4C

Transducer Function
Siren
Frequency Response Min
650Hz
Frequency Response Max
1300Hz
Supply Voltage Min
12V
Tones
Whooping
Length
146.05mm
Current Rating
26mA
Leaded Process Compatible
No
Rohs Compliant
No
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Specifications
and Engineer
Specifications
Architect
Technical
The multiple tone generator shall be a Bogen Model
TG4C, or equivalent, with a rated output level of one
volt RMS into a 600-ohm load.
The device shall be activated by an external contact
closure. It shall be capable of generating four distinct
signals: (1) pulsed alarm tone, (2) slow whoop, (3)
repetitive chime, and (4) steady tone signal.
The pulsed signal shall be a square wave with cycle on-
off timing of 1.2 seconds on, 0.4 seconds off, 1.6 sec-
onds on, and a frequency range of 650-1300 Hz. The
slow whoop signal shall be a slowly ascending, low to
high swept signal with cycle on-off timing of 1.2 sec-
onds on, 0.4 seconds off, 1.6 seconds on, and a fre-
quency range of 500-1200 Hz. The chime tone shall
be a signal with exponential decay slope of 6.5 sec-
onds, cycle on-off timing of 0.3 seconds on, 0.7 sec-
onds off, and a frequency range of 650-1300 Hz. The
steady tone shall be a square wave with adjustable fre-
quency range of 650-1300 Hz. The all-solid-state unit
shall offer a choice of continuous signal of any of the
four tone-types or double-burst signal of any tone
type except the steady tone.
Associated Equipment:
Power Requirements:
Modes of Operation:
Signal Specifications
Load Impedance:
Shipping Weight:
Semiconductors:
Rated Output:
Slow Whoop:
Termination:
Dimensions:
Controls:
Steady:
Chime:
Pulsed:
Finish:
1 volt RMS
600 ohms or higher
Square wave with cycle on-off timing of 1.2 seconds on, 0.4 seconds off,
1.6 seconds on, and frequency range of 650-1300 Hz
Slowly ascending, low to high swept signal with cycle on-off timing of 1.2
seconds on, 0.4 seconds off, 1.6 seconds on, and frequency range of
500-1200 Hz
Signal with exponential decay slope of 6.5 seconds, cycle on-off timing of
0.3 seconds on, 0.7 seconds off, and frequency range of 650-1300 Hz
Square wave with adjustable frequency range of 650-1300 Hz
Choice of continuous signal (until interrupted) of any of four types or two
bursts of pulsed, slow whoop, or chime tone
Tone Level, Pitch
Screw terminals
7 ICs, 4 transistors, 21 diodes
12-48V DC (26 mA @ 24V DC), positive or negative ground
6- 3 / 4 " W x 5- 3 / 4 " H x 2" D
3 lb.
Silver gray
Model PRS40C 120V AC, 60 Hz Power Supply;
Model WMT1A Line-Matching Transformer
The tone generator shall accommodate input from a
high-level program source. Built-in precedence shall
allow the tone signal to override program material.
When used with a public address amplifier, the unit
shall be capable of pre-announce signalling of a voice
announcement over the program source.
Both the output level and pitch control shall be
adjustable. The unit shall operate from 12-48V DC,
positive or negative ground. Construction shall be
steel, finished in silver gray. The overall dimensions
shall be 6-3/4" W x 5-3/4" H x 2" D. The shipping
weight shall be 3 lb.
50 Spring Street, Ramsey, NJ 07446
201-934-8500 FAX: 201-934-9832
www.bogen.com

Related parts for TG4C