P11131000072A BARBER - COLMAN, P11131000072A Datasheet - Page 5

• Manufacturer Part Number: P11131000072A
• Description: Thermocouple
• Manufacturer: BARBER - COLMAN
• Type: J Typer

Specifications of P11131000072A

• Lead Length: 72"
• Thermocouple Type: J
• Terminal Type: Stripped Lead
• Probe Length: 72 In
• Features: Locking Cap
• Lead Free Status / RoHS Status: na

Process Mounting (continued)
Varidepth®, and
Spring Style Varidepth
Adjustable Bushing
Brazed Bushing
Determining Adapter Length
Threaded Adapter
Pipe Clamp Adapter
HA136712
Varidepth is a trade marked mounting device that uses a bayonet type locking cap, and
which is applicable to two different sytles of thermocouples; flexible armor clad, and spring
clad. Each of these protection clads is compressible and therefore provides the pressure
needed to hold the thermocouple tip snugly in the workpiece.
This 1/8" NPT mounting bushing is held in position on the probe with a brass compression
ring secured with a compression nut. Once installed, the compression ring cannot be
relocated. The mounting bushing and compression nut are available in nickel plated brass,
or stainless steel.
This 1/8" NPT mounting bushing in brazed to the sensor probe at the "U" dimension specified
on the order.
To determine the nominal
adapter length, proceed as
follows:
Adapters with 1/8 NPT: "Z"
dimension minus hole depth,
minus 3/8"
Adapters with 3/8-24 thread: "Z" dimension minus hole depth minus 1/4".
Round the adapter length up to the nearest 1/8".
This adapter can be used with thermocouples with bayonet lock
to measure tube or pipe surface temperatures. The thermocouple
is in direct contact with the pipe.
The adapter is available with the "L" dimension in 1/2" increments
beginning with 1-1/2". The "L" dimension of the adapter should
be approximately 9/16" shorter than the "Z" dimension of the probe.
Technical Data
G, H or J Drill
or other workpiece
1" (Ref)
Cylinder Barrel
.687"
1/4" for 1/8 NPT;
3/8" for 3/8-24
X (±1/8")
"U"
Immersion
Depth
("Z" Dimension)
Lock Depth
Adapter Length
"L"
Tap workpiece for
proper thread
Spring Compression
1/8" Miniumum
1/2" Maximum
"A"
Page 2-5