SI-MAG1SM BANNER ENGINEERING, SI-MAG1SM Datasheet - Page 7

• Manufacturer Part Number: SI-MAG1SM
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING
• Type: Reedr

Specifications of SI-MAG1SM

• Sensor Housing: Rectangular
• Output Current: 8A
• Sensor Input: Optical
• Accessory Type: Magnetic Safety Switch Model
• Switch Terminals: Cable
• Body Style: Rectangular
• Function: Proximity
• Ip Rating: IP67
• Primary Type: Proximity
• Range, Measurement: 3-14 mm
• Technology: Reed
• For Use With: Photoelectric Sensor

Switching Elements
Repeat Switching Accuracy
Construction
Environmental Rating
Switching Capacity
Operating Temperature
Connections
Supply Voltage and Current
Sensor Compatibility
Output Configuration
Auxiliary Non-safety
Monitor Contact
Simultaneity - Monitoring
Period
Status Indicators
Housing
Mounting
Wire Connections
Operating Temperature
Dimensions
Certifications
Banner Engineering Corp.
www.bannerengineering.com • Tel: [phone]
•
Minneapolis, MN U.S.A.
Three pole-stable reed switches
±0.1 mm (±0.004")
Epoxy-encapsulated circuit in polyamide housing
IEC IP67
30V dc max @0.25W
-5° to +70°C (+23° to +158°F)
Integral PVC-jacketed 3 m (10') 4-wire cable. Cable O.D. is 5 mm (0.2"). Wires are 24 AWG (0.25 mm
24V dc ±15% (15% maximum ripple) at less than 100mA
All magnet sensor models listed on page 1
Two series-connected (redundant) normally-open safety relay contacts
NOTE: Transient suppression is recommended when switching inductive loads. Install suppressors across
load. Never install suppressors across output contacts
Maximum Voltage: 120V ac, 24V dc
Maximum Current: 0.25A (ac), 1.0 A (dc)
The inputs from the sensor (terminals 1.1/1.2 and 1.3/1.4) must switch within 0.5 seconds of each other
Green - Power ON
Red - Sensor/Magnet out of position or open circuit in sensor wiring
Polycarbonate; Rated NEMA 1, IEC IP20
Mounts to standard 35 mm DIN rail track. Must be installed inside an enclosure rated NEMA 3, IEC IP54 or better.
Screw terminals with pressure plates accept wire size:
0.2 mm
0° to +55°C (+32° to +131°F)
See drawing on page 8.
2
Contact Material:
Contact Ratings:
(26 AWG) min. to 2.5 mm
Magnet Style Controller Specifications
Magnet Style Sensor Specifications
Maximum Voltage: 250V ac
Maximum Current: 8A ac
Maximum Power: 1700VA
Mechanical Life:
Electrical Life:
silver-nickel alloy
Machine Safety Switches –
2
(12 AWG) max.
1,000,000 operations
100,000 operations at full resistive load
Magnet Style
2
).
page
7