E2EV-X10C2 Omron, E2EV-X10C2 Datasheet - Page 5

• Manufacturer Part Number: E2EV-X10C2
• Description: Inductive Proximity Sensor
• Manufacturer: Omron
• Series: E2EVr
• Type: All Metal Sensing Inductive Proximity Sensorr

Specifications of E2EV-X10C2

• Sensor Input: Inductive
• Sensing Range: 10mm
• Supply Voltage Range Dc: 12V To 24V
• Switch Terminals: Cable
• Supply Voltage Min: 10VDC
• Sensor Output: NPN, NC
• Sensor Housing: Cylindrical
• Output Type: NPN
• Proximity Sensor Sensing Distance: 10mm
• Proximity Sensor Sensing Distance Range: 7 to 15mm
• Proximity Sensor Switching Mode: NC
• Mounting: Panel
• Operating Temp Range: -10C to 55C
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 10V
• Operating Supply Voltage (typ): 12/15/18/24V
• Operating Supply Voltage (max): 30V
• Pin Count: 3
• Maximum Operating Temperature: + 55 C
• Supply Voltage: 30 V
• Operating Supply Voltage: 10 V to 30 V
• Sensing Distance: 10 mm
• Minimum Operating Temperature: - 10 C
• Maximum Output Current: 15 mA
• Features: One sensor detects all kinds of metal at equal distance
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Safety Precautions
Refer to Warranty and Limitations of Liability.
This product is not designed or rated for ensuring
safety of persons either directly or indirectly.
Do not use it for such purposes.
Do not use this product under ambient conditions that exceed the
ratings.
● Design
Influence of Surrounding Metal
When mounting the Sensor within a metal panel, ensure that the
clearances given in the following table are maintained. Failure to
maintain these distances may cause deterioration in the performance
of the Sensor.
Influence of Surrounding Metal
Mutual Interference
When installing Sensors face-to-face or side-by-side, ensure that the
minimum distances given in the following table are maintained.
Mutual Interference
Model
E2EV-X2C@
E2EV-X5C@
E2EV-X10C@
Model
E2EV-X2C@
E2EV-X5C@
E2EV-X10C@
l
m
Precautions for Correct Use
Item
Item
100
30
50
A
(Unit: mm)
0
l
WARNING
20
35
70
B
D
12
18
30
d
d dia.
(Unit: mm)
D
0
20
40
m
B
8
A
l
m
n
18
27
45
n
● Mounting
Do not tighten the nut with excessive force. A toothed washer must be
used with the nut.
Note: 1. The allowable tightening strength depends on the distance from the
Model
E2EV-X2C@
E2EV-X5C@
E2EV-X10C@
Tightening Torque
2. The following strength assume washers are being used.
edge of the head, as shown in the following table. (A is the distance
from the edge of the head. B includes the nut on the head side. If the
edge of the nut is in part A, the tightening torque for part A applies
instead.)
Dimension
(mm)
17
22
26
Part A
5.9 N·m
Torque
15 N·m
39 N·m
Part B Part A
E2EV
9.8 N·m
Torque
49 N·m
78 N·m
Part B
5