MLV14-55/49/82A/123/124 PEPPERL & FUCHS, MLV14-55/49/82A/123/124 Datasheet - Page 32

no-image

MLV14-55/49/82A/123/124

Manufacturer Part Number
MLV14-55/49/82A/123/124
Description
Photoelectric Sensor
Manufacturer
PEPPERL & FUCHS
Datasheet

Specifications of MLV14-55/49/82A/123/124

Sensor Input
Optical
Output Type
Transistor
Photoelectric Sensors
Courtesy of Steven Engineering, Inc. ! 230 Ryan Way, South San Francisco, CA 94080-6370 ! Main Office: (650) 588-9200 ! Outside Local Area: (800) 258-9200 ! www.stevenengineering.com
354
MLV11 Series Programming
Automatic Push-button Setting – Dynamic Mode
(for moving targets)
1. If the sensor’s push buttons are locked (usually when
2. Press the "+" and "-" buttons simultaneously for one
3. Move the target perpendicularly past the sensor at the
4. Press either the "+" or "-" button to store the switch
the sensor is connected to a supply voltage), then
simultaneously press "+" and "-" buttons for five
seconds (until the green LED flashes once). The sensor
is now unlocked. If the green LED is flashing
continuously, then the sensor is already in the "teach"
mode, and step 2 should be skipped.
second, until the red LED turns off. The green LED will
be flashing at 2 Hz which indicates the sensor is in
"teach" mode.
desired sensing distance. The green LED will flash
briefly at a higher switching frequency (4 Hz), although
the time the green LED is flashing at a higher frequency
may be too short to be observed. When the green LED
flashes at 2 Hz again, the sensor is out of
"teach" mode.
point. The green LED will be lit continuously and the
yellow LED will indicate output status. If the red LED is
lit, then there is an error, and steps 2, 3, and 4 should
be repeated.
PEPPERL+FUCHS
Pepperl+Fuchs Inc. • 1600 Enterprise Parkway • Twinsburg, Ohio 44087-2245 • www.am.pepperl-fuchs.com
Telephone (330) 486-0001 • FAX (330) 405-4710 • E-Mail: sales@us.pepperl-fuchs.com
®
M11/MV11 Series
Push-button Programming Instructions
There are two ways to set the switch point for this series:
manual setting and automatic setting.
Manual Push-button Setting
1. Align the transmitter and receiver facing each other, with
2. If the sensor’s push buttons are locked (usually when
3. Adjust the sensitivity of the sensor by pressing the "+"
Automatic Push-button Setting
1. Align the transmitter and receiver, with the light beam
2. If the sensor’s push buttons are locked (usually when
the light beam between the two unobstructed.
the sensor is connected to a supply voltage), then
simultaneously press "+" and "-" buttons (which are
only located on the receiver housing) for five seconds
(until the green LED flashes once). The sensor is now
unlocked.
or "-" button. Either button can be pressed and held
down to repeat the function. The red LED flashes
whenever either button is pressed, and the yellow LED
indicates output status. If the red LED does not flash
when either button is pressed, then the sensor is either
at the end of the adjustable range or it is no longer
unlocked, and steps 1, 2, and 3 should be repeated.
between the two unobstructed.
the sensor is connected to a supply voltage), then
simultaneously press "+" and "-" buttons for five
seconds (until the green LED flashes once). The sensor
is now unlocked.
Receiver
Receiver

Related parts for MLV14-55/49/82A/123/124