M12NLPQ8 BANNER ENGINEERING, M12NLPQ8 Datasheet - Page 4

• Manufacturer Part Number: M12NLPQ8
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING

Specifications of M12NLPQ8

• Output Current: 100mA
• Sensor Output: NPN
• Supply Voltage Range Dc: 10V To 30V
• Sensor Housing: Barrel
• Sensor Input: Optical
• Body Material: Nickel-Plated Brass
• Supply Voltage Max: 30VDC
• Sensing Range Max: 1.5m

4
M12 Series Metal Barrel Sensors
Sensing Beam
Supply Voltage and
Current
Supply Protection
Circuitry
Output Configuration
Output Ratings
Output Protection
Circuitry
Output Response Time
Repeatability
Indicators
Adjustments
Construction
Environmental Rating
Connections
Operating Conditions
Application Notes
Certifications
P/N 129721 rev. D
Fixed-Field Models: 680 nm visible red
All Other Models: 660 nm visible red
10 to 30V dc (10% max. ripple) @ 20 mA max current, exclusive of load
Protected against reverse polarity and transient voltages
Complementary (1 normally open and 1 normally closed) solid-state, NPN or PNP, depending on model
100 mA total across both outputs with overload and short circuit protection
OFF-state leakage current:
Protected against false pulse on power-up, short-circuit protected
Opposed Mode: 1 ms ON and OFF
All Other Modes: 500 µs ON and OFF
NOTE: 100 ms delay on power-up; outputs do not conduct during this time.
Opposed Mode: not applicable
All Other Modes: 95 microseconds
Two Status (yellow) and one Power (green) LED (see Figure 1)
Fixed-Field Models: None
All Other Models: Single-turn Gain (sensitivity) potentiometer
Housing: Nickel-plated brass
Lenses: PMMA
Cable Endcap and Gain Potentiometer Adjuster: PBT
IEC IP67; NEMA 6, IEC IP68 and 1200 PSI Washdown, NEMA ICS 5 Annex F-2002
2 m (6.5') or 9 m (30') 4-wire PVC-jacketed cable, 4-pin integral Euro-style QD fitting,
or 4-pin 150 mm (6") Euro-style pigtail, depending on model
Operating temperature: −20° to +60° C (−4° to +140° F)
Relative humidity: 90% max @ +50° C (+122° F) non-condensing
1. NPN off-state leakage current is < 200 μA for load resistances > 3 kΩ or optically isolated loads.
For load current of 100 mA, leakage is < 1% of load current
NPN: less than 200 µA @ 30V dc (see Application Note 1)
PNP: less than 10 µA @ 30V dc
Specifications
Banner Engineering Corp. • Minneapolis, MN U.S.A
www.bannerengineering.com • Tel: [phone]
ON-state saturation voltage:
NPN: less than 1.6V @ 100 mA
PNP: less than 3.0V @ 100 mA