D12SP6FVQ BANNER ENGINEERING, D12SP6FVQ Datasheet - Page 4

• Manufacturer Part Number: D12SP6FVQ
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING
• Type: High Powerr

Specifications of D12SP6FVQ

• Sensor Output: PNP
• Peak Reflow Compatible (260 C): No
• Sensor Housing: Rectangular
• Sensing Range Min: 100mm
• Sensor Input: Fiber Optic
• Sensing Range Max: 0.1mm
• Leaded Process Compatible: No
• Mounting Type: DIN Rail
• Fiber Optic Sensor Type: High Power

Excess gain curves for plastic fibers
in the diffuse sensing mode are given
to the right (top row). Fiber sizes are
noted on the curves.
Excess gain curves for plastic fibers
in the opposed mode are given below
(bottom row). Fiber sizes are noted on
the curves. The curve at the far lower
right uses model L2 lenses for extended
sensing range.
Range and gain information for D12FP, D12FPY, & D12FPY1 Series plastic fiber optic sensors
* Include "Q" in model suffix to specify 6-inch pigtail with 4-pin pico-style QD.
Banner Engineering Corp.
D12SN6FP(Q)*
D12SN6FPY(Q)*
D12SN6FPY1(Q)*
D12SP6FP(Q)*
D12SP6FPY(Q)*
D12SP6FPY1(Q)*
D12 Series
Omit "Q" to specify models with 6-foot attached cable.
Models with 30-foot attached cable are available.
*Response Mode Selection on
FPY and FPY1
models only
D12 Dimensions and Fea-
tures
(plastic fiber optic models)
NPN sinking complementary outputs (with selectable 50µs high speed response mode)
NPN sinking complementary outputs (with selectable 50µs high speed response mode and 20 ms pulse stretcher)
PNP sourcing complementary outputs (standard 500µs response time)
PNP sourcing complementary outputs (with selectable 50µs high speed response mode)
PNP sourcing complementary outputs (with selectable 50µs high speed response mode and 20 ms pulse stretcher)
9714 Tenth Avenue No., Minneapolis, MN 55441
DIN RAIL Plastic Fiber Optic Sensors
NPN sinking complementary outputs (standard 500µs response time)
Telephone [phone]
Plastic fiber installation:
1) Cut fiber ends per instructions included with the
fibers. Slide the fiber gripper up (open).
If .010" or .020" dia. fibers are used, insert the adaptor
(drawing above) into the ports as far as it will go.
2) All fibers: Insert the prepared plastic fiber sensor
ends gently into the ports as far as they will go.
Slide the fiber gripper back down to lock.
Adaptor (included)
is for use with
.010" or .020"
diameter fibers.
FAX [phone]