1TL1-6F Honeywell Sensing and Control, 1TL1-6F Datasheet

Page 1

Sensing and Control Interactive Catalog... www.honeywell.com/sensing ...

Page 2

... Application Note: Honeywell MICRO SWITCH does not recommend the use of silver cadmium oxide switch contacts in non-arcing loads. Non-arcing loads are generally loads less than 12 volts and/or 0.5 amp. TL switches use silver cadmium oxide contacts. For other options, contact the MICRO SWITCH Application Center at 1-800-537-6945 ...

Page 3

... One pole Two pole Four pole TERMINALS In addition to the screw terminal switches listed in the order guides, IWTS Integrat- ed Wire Termination System versions (covered in MICRO SWITCH Catalog 80) and solder turret terminals are available. Contact the 800 number. ...

Page 4

... MS number. For example, to or- der a 1TL1-1 pull-to-unlock toggle switch with the lever locked in the center posi- tion, add the letter E; i.e., 1TL1-1E, MS-24658-21E. LOCKING CONFIGURATIONS A B Locked In ...

Page 5

... MIL-S-3950. They have the same circuitry and electrical ratings as their 1TL, 2TL, and 4TL counterparts. For example, 11TL1-2 is the same as 1TL1-2, except it has solder turret terminals instead of screw terminals. The complete MS draw- ing numbers are shown in data sheet 204. ...

Page 6

... Manual Switches Toggle Switches MOUNTING DIMENSIONS (For reference only) One pole Note: Terminal screws, and mounting hardware (locking ring, lockwasher, and two hexnuts) are furnished unassembled. 0,0 mm Key: 0.00 inches Bushing mounting torque is 10–15 in./lbs. Terminal screw mounting torque is 5 in./lbs. max. ...