A7PH-206-1 Omron, A7PH-206-1 Datasheet - Page 7

• Manufacturer Part Number: A7PH-206-1
• Description: Thumbwheel Switch,BCD,ON-ON,Number Of Positions:1,SOLDER Terminal,THUMBWHEEL
• Manufacturer: Omron
• Series: A7PHr

Specifications of A7PH-206-1

• Output Code: BCD
• Read Out: 0 ~ 9
• Actuator Type: Pushwheel
• Mounting Type: Panel Mount, Snap-In (Front)
• Termination Style: Card Edge
• Component Mounting Area: No
• Actuator: Thumbwheel
• Number Of Sections: 1
• Contact Rating: 3 Amps
• Readout: 0-9
• Switch Terminals: Solder
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: A7PH2061

Connectors
These devices allow Switches to be quickly removed for maintenance and inspection of connectivity, and quickly re-installed.
Safety Precautions
■ Precautions for Correct Use
Please observe the following precautions to prevent failure to
operate, malfunction, or undesirable effect on product performance.
Refer to Precautions for Correct Use on page 4 for information
common to all models.
Handling
The molded components of the Switch use polyacetal resin and ABS
resin. It is recommended that alcohol is used to wipe off dirt and
smudges from the molded components. Take care to prevent the
alcohol from getting inside.
Do not use thinner or other solutions which might damage the resin.
Do not push the (+) and (–) operating push-buttons at the same time.
44
Note: Unless otherwise indicated, dimensional tolerances for dimensions in the models above are ± 0.4 mm.
Cat. No. A154-E1-01A
NRT-C
Solder Terminals
Inserting Connectors
Insert Connectors with the "UP" arrow pointing up.
7.8
−0.3
−0.3
0
Thumbwheel Switch
30
25.4
+0.3
0
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
Two, 3.3 dia.
Connector
In the interest of product improvement, specifications are subject to change without notice.
A7PS/A7PH
NRT-CN
Solder Terminals
25.4
Soldering
Refer to Precautions for Correct Use on page 4.
1×2
elliptic
hole
7.8
+0.03
−0.3
NRT-CP
PCB Terminals
30
25.4
+0.3
0