M80-6900398 Harwin Inc, M80-6900398 Datasheet - Page 6

• Manufacturer Part Number: M80-6900398
• Description: CONN RECEPT 2MM 3POS CRIMP
• Manufacturer: Harwin Inc
• Series: Datamate Trio-Tekr

Specifications of M80-6900398

• Connector Type: Receptacle
• Contact Termination: Crimp
• Note: Contacts Not Provided
• Contact Type: Female Socket
• Number Of Positions: 3
• Pitch: 0.079" (2.00mm)
• Number Of Rows: 1
• Mounting Type: Free Hanging (In-Line)
• Fastening Type: Latch Lock
• Color: Black
• Gender: Socket
• No. Of Contacts: 3
• No. Of Rows: 1
• Pitch Spacing: 2mm
• Svhc: No SVHC (15-Dec-2010)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Row Spacing: -
• Features: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 952-1601

APPENDIX A - Contact Orientations
These diagrams show examples of contact numbering with reference to the polarisation feature. They
represent female connectors, without jackscrews.
APPENDIX B - Instructions For The Use of J-Tek Housings Fitted With Jackscrews
Connectors are fitted with jackscrews where it is considered necessary to provide mechanical assistance in
ensuring a satisfactory engagement and separation of the connector. This may apply in cases where
engagement and separation forces are so high as to prevent satisfactory hand engagement, or where
access to the connector is restricted. Jackscrews also provide a locking feature, preventing the connector
from disengaging under adverse conditions.
In order to obtain maximum effectiveness from the jackscrew system, the following rules for their use
should be observed:
1. The connector with the fixed jackscrew should be fixed to the mounting board by means of the male
2. On engaging the two halves of the connector after ensuring correct polarity, lightly push home the
3. On disengaging the two halves of the connector turn each of the floating jackscrews anti-clockwise.
thread on the jackscrew, and the supplied M2 nut. The nut should be tightened to a torque of 21±cmN.
floating half until the jackscrews touch. Then, maintaining the pressure, turn one of the floating
jackscrews clockwise, until it engages with the fixed screw. Repeat with the other screw.
Then screw in each jackscrew, ensuring even loading by applying a maximum of one turn to each screw
in sequence until the connector is bottomed. This will be evident by a sudden increase in the torque
required on the screw. This torque should not exceed 23Ncm.
NB: Care should be taken when aligning male and female threads, to avoid cross-threading and possible
failure of parts.
Again ensure even loading by turning each screw in sequence for a maximum of one turn until the
jackscrews disengage. The connector can then be easily pulled apart.
Appendix A & B
C04008
Issue: 8
Change Note: 11076
Date: 06/01/2011
C04008